CLI Command Mode Prompt Access CommandLLDP MANAGEMENT INTERFACE Dell(conf-lldp-mgmtIf)# management-interface (LLDPMode)LINE Dell(config-line-console)or Dell(config-line-vty)line console orline vtyMONITOR SESSION Dell(conf-mon-sess-sessionID)#monitor sessionOPENFLOW INSTANCE Dell(conf-of-instance-of-id)#openflow of-instancePORT-CHANNEL FAILOVER-GROUPDell(conf-po-failover-grp)#port-channel failover-groupPRIORITY GROUP Dell(conf-pg)# priority-groupPROTOCOL GVRP Dell(config-gvrp)# protocol gvrpQOS POLICY Dell(conf-qos-policy-out-ets)#qos-policy-outputVLT DOMAIN Dell(conf-vlt-domain)# vlt domainVRRP Dell(conf-if-interface-type-slot/port-vrid-vrrp-group-id)#vrrp-groupu-Boot Dell(=>)# Press any key when the followingline appears on the consoleduring a system boot: Hit anykey to stop autoboot:UPLINK STATE GROUP Dell(conf-uplink-state-group-groupID)#uplink-state-groupThe following example shows how to change the command mode from CONFIGURATION mode toPROTOCOL SPANNING TREE.Example of Changing Command ModesDell(conf)#protocol spanning-tree 0Dell(config-span)#The do CommandYou can enter an EXEC mode command from any CONFIGURATION mode (CONFIGURATION,INTERFACE, SPANNING TREE, and so on.) without having to return to EXEC mode by preceding the EXECmode command with the do command.The following example shows the output of the do command.Slot Status NxtBoot ReqTyp CurTyp Version Ports------------------------------------------------0 not present1 not present38 Configuration Fundamentals
