The Alert Recurrence page is displayed.2. In the Recurrence column, enter the alert frequency value for the required category, alert, and severity type(s).For more information, see the iDRAC Online help.3. Click Apply.The alert recurrence settings are saved.Setting alert recurrence events using RACADMTo set the alert recurrence event using RACADM, use the eventfilters command. For more information, see the iDRAC RACADMCommand Line Interface Reference Guide available at dell.com/idracmanuals.Setting event actionsYou can set event actions such as perform a reboot, power cycle, power off, or perform no action on the system.Related linksFiltering alertsEnabling or disabling alertsSetting event actions using web interfaceTo set an event action:1. In iDRAC Web interface, go to Overview → Server → Alerts. The Alerts page is displayed.2. Under Alerts Results, from the Actions drop-down menu, for each event select an action:• Reboot• Power Cycle• Power Off• No Action3. Click Apply.The setting is saved.Setting event actions using RACADMTo configure an event action, use the eventfilters command. For more information, see the iDRAC RACADM Command LineInterface Reference Guide available at dell.com/idracmanuals.Configuring email alert, SNMP trap, or IPMI trap settingsThe management station uses Simple Network Management Protocol (SNMP) and Intelligent Platform Management Interface(IPMI) traps to receive data from iDRAC. For systems with large number of nodes, it may not be efficient for a management stationto poll each iDRAC for every condition that may occur. For example, event traps can help a management station with load balancingbetween nodes or by issuing an alert if an authentication failure occurs. SNMP v1, v2, and v3 formats are supported.You can configure the IPv4 and IPv6 alert destinations, email settings, and SMTP server settings, and test these settings. You canalso specify the SNMP v3 user to whom you want to send the SNMP traps.Before configuring the email, SNMP, or IPMI trap settings, make sure that:• You have Configure RAC permission.• You have configured the event filters.156
