Operating System LocationNOTE: The location of the Lifecycle log can beconfigured using the iDRAC Service Module installer.You can configure the location while installing iDRACService Module or modifying the installer.Red Hat Enterprise Linux, SUSE Linux, CentOS, and CitrixXenServer/var/log/messagesVMware ESXi /var/log/syslog.logWhat are the Linux-dependent packages or executables available for installation while completing the Linux installation?To see the list of Linux-dependent packages, see the Linux Dependencies section in the iDRAC Service Module Installation Guide.RACADMAfter performing an iDRAC reset (using the racadm racreset command), if any command is issued, the following message isdisplayed. What does this indicate?ERROR: Unable to connect to RAC at specified IP addressThe message indicates that you must wait until the iDRAC completes the reset before issuing another command.When using RACADM commands and subcommands, some errors are not clear.You may see one or more of the following errors when using the RACADM commands:• Local RACADM error messages — Problems such as syntax, typographical errors, and incorrect names.• Remote RACADM error messages — Problems such as incorrect IP Address, incorrect user name, or incorrect password.During a ping test to iDRAC, if the network mode is switched between Dedicated and Shared modes, there is no pingresponse.Clear the ARP table on your system.Remote RACADM fails to connect to iDRAC from SUSE Linux Enterprise Server (SLES) 11 SP1.Make sure that the official openssl and libopenssl versions are installed. Run the following command to install the RPM packages:rpm -ivh --force < filename >where, filename is the openssl or libopenssl rpm package file.For example:rpm -ivh --force openssl-0.9.8h-30.22.21.1.x86_64.rpmrpm -ivh --force libopenssl0_9_8-0.9.8h-30.22.21.1.x86_64.rpmWhy are the remote RACADM and web-based services unavailable after a property change?It may take a while for the remote RACADM services and the Web-based interface to become available after the iDRAC web serverresets.The iDRAC Web server is reset when:• The network configuration or network security properties are changed using the iDRAC web user interface.• The iDRAC.Webserver.HttpsPort property is changed, including when a racadm set -f changes it.• The racresetcfg command is used.302
