• iDRAC is reset.• A new SSL server certificate is uploaded.Why is an error message displayed if you try to delete a partition after creating it using local RACADM?This occurs because the create partition operation is in-progress. However, the partition is deleted after sometime and a messagethat the partition is deleted is displayed. If not, wait until the create partition operation is completed and then delete the partition.MiscellaneousHow to find an iDRAC IP address for a blade server?• Using CMC web interface:Go to Chassis → Servers → Setup → Deploy. In the table that is displayed, view the IP address for the server.• Using the Virtual Console: Reboot the server to view the iDRAC IP address during POST. Select the "Dell CMC" console in theOSCAR to log in to CMC through a local serial connection. CMC RACADM commands can be sent from this connection.For more information on CMC RACADM commands, see the CMC RACADM Command Line Interface Reference Guideavailable at dell.com/esmmanuals.For more information on iDRAC RACADM commands, see the iDRAC RACADM Command Line Interface Reference Guideavailable at dell.com/idracmanuals.• Using local RACADMUse the command: racadm getsysinfo For example:$ racadm getniccfg -m server-1DHCP Enabled = 1IP Address = 192.168.0.1Subnet Mask = 255.255.255.0Gateway = 192.168.0.1• Using LCD:On the main menu, highlight the server, press the check button, select the required server, and press the check button.How to find the CMC IP address related to the blade server?• From iDRAC web interface:Go to Overview → iDRAC Settings → CMC. The CMC Summary page displays the CMC IP address.• From the Virtual Console:Select the "Dell CMC" console in the OSCAR to log in to CMC through a local serial connection. CMC RACADM commands canbe issued from this connection.$ racadm getniccfg -m chassisNIC Enabled = 1DHCP Enabled = 1Static IP Address = 192.168.0.120Static Subnet Mask = 255.255.255.0Static Gateway = 192.168.0.1Current IP Address = 10.35.155.151Current Subnet Mask = 255.255.255.0Current Gateway = 10.35.155.1Speed = AutonegotiateDuplex = AutonegotiateNOTE: You can also perform this using remote RACADM.For more information on CMC RACADM commands, see the CMC RACADM Command Line Interface Reference Guideavailable at dell.com/esmmanuals.For more information on iDRAC RACADM commands, see the iDRAC RACADM Command Line Interface Reference Guideavailable at dell.com/idracmanuals.303
