After you configure iDRAC IP address:• Ensure that you change the default user name and password after setting up the iDRAC IP address.• Access iDRAC through any of the following interfaces:– iDRAC Web interface using a supported browser (Internet Explorer, Firefox, Chrome, or Safari)– Secure Shell (SSH) — Requires a client such as PuTTY on Windows. SSH is available by default in most of the Linuxsystems and hence does not require a client.– Telnet (must be enabled, since it is disabled by default)– IPMITool (uses IPMI command) or shell prompt (requires Dell customized installer in Windows or Linux, available fromSystems Management Documentation and Tools DVD or dell.com/support)Related linksSetting up iDRAC IP using iDRAC settings utilitySetting up iDRAC IP using CMC web interfaceEnabling provisioning serverConfiguring servers and server components using Auto ConfigSetting up iDRAC IP using iDRAC settings utilityTo set up the iDRAC IP address:1. Turn on the managed system.2. Press during Power-on Self-test (POST).3. In the System Setup Main Menu page, click iDRAC Settings.The iDRAC Settings page is displayed.4. Click Network.The Network page is displayed.5. Specify the following settings:• Network Settings• Common Settings• IPv4 Settings• IPv6 Settings• IPMI Settings• VLAN Settings6. Click Back, click Finish, and then click Yes.The network information is saved and the system reboots.Related linksNetwork settingsCommon settingsIPv4 settingsIPv6 settingsIPMI settingsVLAN settingsNetwork settingsTo configure the Network Settings:NOTE: For information about the options, see theiDRAC Settings Utility Online Help.1. Under Enable NIC, select the Enabled option.2. From the NIC Selection drop-down menu, select one of the following ports based on the network requirement:40
