• Enabled while server has default credential settings only• EnabledFor information about the fields, see the iDRAC Settings Utility Online Help.4. Click Back, click Finish and then click Yes to apply the settings.Importing server configuration profile from USB deviceMake sure to create a directory in root of the USB device called System_Configuration_XML which contains both the config.xmland control.xml files:• Server Configuration Profile is in the System_Configuration_XML sub-directory under the USB device root directory. This fileincludes all the attribute-value pairs of the server. This includes attributes of iDRAC, PERC, RAID, and BIOS. You can edit this fileto configure any attribute on the server. The file name can be -config.xml, -config.xml, orconfig.xml.• Control XML file – Includes parameters to control the import operation and does not have attributes of iDRAC or any othercomponent in the system. The control file contain three parameters:– ShutdownType – Graceful, Forced, No Reboot.– TimeToWait (in secs) – 300 minimum and 3600 maximum.– EndHostPowerState – on/off.Example of control.xml file: ConfigurationXML import Host control InstructionShutdownType NoRebootValue> Graceful,Forced,NoRebootValuePossibilities> Configuration XML import Host control InstructionInstructionType> TimeToWait300 Minimum value is 300 -Maximum valueis 3600 seconds. Configuration XML import Host controlInstruction EndHostPowerStateInstruction> On On,OffValuePossibilities> You must have Server Control privilege to perform this operation.NOTE: While importing the server configuration profile, changing the USB management settings in the XML file resultsin a failed job or job completed with errors. You can comment out the attributes in the XML to avoid the errors.To import the server configuration profile from the USB device to iDRAC:1. Configure the USB management port:• Set USB Management Port Mode to Automatic or iDRAC.• Set iDRAC Managed: USB XML Configuration to Enabled with default credentials or Enabled.2. Insert the USB key (that has the configuration.xml and the control.xml file) to the iDRAC USB port.3. The server configuration profile is discovered on the USB device in the System_Configuration_XML sub-directory under theUSB device root directory. It is discovered in the following sequence:• -config.xml• -config.xml• config.xml4. A server configuration profile import job starts.If the profile is not discovered, then the operation stops.If iDRAC Managed: USB XML Configuration was set to Enabled with default credentials and the BIOS setup password is notnull or if one of the iDRAC user accounts have been modified, an error message is displayed and the operation stops.5. LCD panel and LED (if present) display the status that an import job has started.272
