Uploading server certificate using web interfaceTo upload the SSL server certificate:1. In the iDRAC Web interface, go to Overview → iDRAC Settings → Network → SSL, select Upload Server Certificate andclick Next.The Certificate Upload page is displayed.2. Under File Path, click Browse and select the certificate on the management station.3. Click Apply.The SSL server certificate is uploaded to iDRAC.4. A pop-up message is displayed asking you to reset iDRAC immediately or at a later time. Click Reset iDRAC or Reset iDRACLater as required.iDRAC resets and the new certificate is applied. The iDRAC is not available for a few minutes during the reset.NOTE: You must reset iDRAC to apply the new certificate. Until iDRAC is reset, the existing certificate is active.Uploading server certificate using RACADMTo upload the SSL server certificate, use the sslcertupload command. For more information, see the RACADM Command LineReference Guide for iDRAC available at dell.com/idracmanuals.If the CSR is generated outside of iDRAC with a private key available, then to upload the certificate to iDRAC:1. Send the CSR to a well-known root CA. CA signs the CSR and the CSR becomes a valid certificate.2. Upload the private key using the remote racadm sslkeyupload command.3. Upload the signed certificate to iDRAC using the remote racadm sslcertupload command.The new certificate is uploaded iDRAC. A message is displayed asking you to reset iDRAC.4. Run the racadm racreset command to reset iDRAC.iDRAC resets and the new certificate is applied. The iDRAC is not available for a few minutes during the reset.NOTE: You must reset iDRAC to apply the new certificate. Until iDRAC is reset, the existing certificate is active.Viewing server certificateYou can view the SSL server certificate that is currently being used in iDRAC.Related linksSSL server certificatesViewing server certificate using web interfaceIn the iDRAC Web interface, go to Overview → iDRAC Settings → Network → SSL. The SSL page displays the SSL servercertificate that is currently in use at the top of the page.Viewing server certificate using RACADMTo view the SSL server certificate, use the sslcertview command.For more information, see the iDRAC RACADM Command Line Interface Reference Guide available at dell.com/idracmanuals.Uploading custom signing certificateYou can upload a custom signing certificate to sign the SSL certificate. SHA-2 certificates are also supported.Uploading custom signing certificate using web interfaceTo upload the custom signing certificate using iDRAC web interface:1. Go to Overview → iDRAC Settings → Network → SSL.96
