Local Inputs TabPage 26 of 84 eZV-440 Application GuideEdition 2.6Local Inputs TabSetting Up a Hardwired Temperature SensorThis topic describes how to set up a temperature sensor using the Local Inputs tab on theconfiguration page.Occupancy overrides can share the same input as the temperature sensor.If you are setting up a LINKnet DNS-24L or eZNS network sensor to provide occupancyinput, use the LINKnet I/O tab on the configuration page.Set Up a Hardwired Temperature Sensor1. Wire your sensor to the controller's physical input.2. Next to the input number that you've assigned to the sensor, in the Function field, select oneof the following options:Function Select this option if you are using a:DischargeAirTemp_ Duct temperature sensor that is located downstream from anylocal heating or cooling stages that supply the air to that space.InletAirTemp_ (VAV application type only) Duct temperature sensor that islocated upstream from local heating or cooling stages thatsupply the air to that space.SpaceTemp_ Space temperature sensor, or a network value from a DNS oreZNS network sensor on LINKnet.You can set up multiple SpaceTemp inputs and by default thealgorithm will calculate the average of all inputs and assign thatvalue to the AV1 object.SpcTemp+OccOvrdButton_Space temperature sensor and the occupancy override pushbutton are wired into the same input.This can be a normally open contact wired in parallel or anormally closed contact wired in series with the temperaturesensor.
