Local Outputs TabPage 36 of 84 eZV-440 Application GuideEdition 2.6Setting Up Other OutputsThis topic describes how to set up supporting outputs like occupancy indicator on the Local Outputstab of the enteliZONE configuration page.Set Up an Output1. In the Function field, select the option that applies to your setup:Function Select this option if youare:OccIndicator_ Setting up an occupancyoutput signal.Any one of the following: ElectricBaseboard_,HydronicBaseboard_Controlling radiant heatingequipment.GCL-controlled AO_* Creating a custom AO object.GCL-controlled BO_* Creating a custom BO object.* Available only with programmable enteliZONE models and only on output terminals thatsupport AO or BO objects.For a list of output configuration software objects that correspond to each function, see theOutput Configuration Objects topic.2. In the Stage field, for the radiant heating equipment, select the radiant heating equipment'sheat stage in the control sequence. If you are using ORCAview,select the heat stage in theOutput Stage field.Function Stage or Output StageOccIndicator_ OccIndicator_ is the defaultoption.Any one of the following: ElectricBaseboard_,HydronicBaseboard_Select one: Heat1_, Heat2_ orHeat3_.GCL-controlled AO_ None_ is the default option.GCL-controlled BO_ None_ is the default option.3. In the Control Type field, select the method of control used on the output device signal.The control types available in the drop-down list will change depending on the option thatwas selected in the Function field and the physical output used to connect to the outputdevice. For more information about control types, see the Control Types topic.4. In the Action field, choose between direct or reverse control.
