ENGLISH19ENGLISHConnecting Other Sources Connecting Other SourcesZONE2 / ZONE3 speaker out connections• When the power amplifier is assigned to the ZONE2 or ZONE3 output channel at “Power Amp Assign” in the“System Setup Menu”, the MAIN ZONE speaker terminals can be used as the ZONE2 or ZONE3 speaker outterminals ( page 49, 50).• The connections diagram below is an example for when the surround back speaker is assigned to the ZONE2stereo 2 channel.In this case, Surround Back Speaker OUT can not be used for MAIN ZONE.> < < >> <> <> < > < < >< >< >IN(L)(R)(R) (R) (L)(L)(L)(R)Connection terminalfor subwoofer withbuilt-in amplifier(subwoofer), etc.Surroundleft speaker(A)SubwooferFrontright speakerSurroundleft speaker (B)ZONE2 Frontleft speakerFrontleft speakerCenterspeakerZONE2 Frontright speakerSurroundright speaker (B)Surroundright speaker(A)Connecting the pre-out terminalsPower amplifierRSURROUNDBACKLRSURROUNDLRFRONTLCENTERSUB-WOOFERRLRLBABARLRLRLRLA• Use these terminals if you wish to connect external power amplifier(s) to increase the power of the front,center, surround and surround back sound channels, or for connection to powered loudspeakers.• When using only one surround back speaker, connect it to left channel.Connecting the power supply cordAC 230V, 50HzAC outlets(wall)Power supply cord(Supplied)NOTE:• Only use the AC OUTLET for audio equipment. Never use them for hair driers, TVs or other electricalappliances.• Insert the plugs securely. Incomplete connections will result in the generation of noise.AC OUTLET• SWITCHED (total capacity – 100 W)The power to the outlet is turned on and off inconjunction with the POWER switch on the main unit,and when the power is switched between on andstandby from the remote control unit.No power is supplied from this outlet when thisunit’s power is at standby. Never connect equipmentwhose total capacity is above 100 W.ZONE2