Denon AVC-A11XV Operating Instructions Manual

Also see for AVC-A11XV: Operating instructions Control protocol Service manual

Contents

Denon AVC-A11XV Operating Instructions Manual Manual pdf 38 page image

35ENGLISHAdvanced Operation Advanced OperationENGLISH4. Monitor TV (TV), digital broadcastsatellite (DBS) tuner and cable(CABLE) system buttonsRC-995SRC ON : Power on/StandbySETUP : SetupTOP : Top menuMENU : MenuRTN : Returnc, d, b, a : Cursor up, down, left and rightENTER : EnterDISP : Switch displayCH +, – : Switch channels +, –0 ~ 9, +10 : NumberTV/VCR : Switch between TVand video player•, ª : Volume up/down3. Video deck (VCR-1/VCR-2) systembuttonsRC-995SRC ON : Power on/Standby6, 7 : Manual search(forward and reverse)2 : Stop1 : Play3 : Pause0 ~ 9, +10 : Number5 Point the remote control units directlyat each other and press and hold in thebutton on the other remote control unitwhich you want to “learn”.• “OK” appears on the remote control unit’sdisplay and learning is completed.Other remotecontrol unitOther keys can be “learned” by repeating steps5.“FAIL” appears on the remote control unit’sdisplay, repeating steps 4 and 5.The mode can be switched by pressing a MODESELECTOR button.The buttons that allow learning display reappearsand the learning standby mode is set.Learning functionOFFCHANNEL( )ONMODE SELECTORNUMBERSYSTEM CALLENTERIf an AV component is not a DENON product, or if itcannot be operated via codes provided in the AVC-A11XV remote control's internal preset memory, or ifits codes cannot be successfully learned by the AVC-A11XV remote control, then you should use theremote control that was supplied with that AVcomponent to operate the component.1 Press the ON and OFF button at thesame time.2 Press the 2 button to select Learningsetup.3 Press the MODE SELECTOR button forthe component you want to learned,then press the ENTER button.• Buttons that allow learning will light.4 Press the button that you wish to belearned.• The display will go off and the unit will enterthe learning standby mode.The preset codes of cable box decoder can berecorded in the DBS mode so that the cabledevice can be operated ( page 33, 34).It is only possible to set the preset memory foreither the DBS or cable device.Learning is not possible for the AMP, ZONE2,ZONE3 and ZONE4 modes.To cancel, press the ON and OFF buttonsimultaneously.• To cancel the learning mode, press the ON and OFFbutton simultaneously again.System callThe accessories remote control unit is equipped with“system call” function allowing a series of remotecontrol signals to be transmitted by pressing a singlebutton.This function can be used for example to turn on theamplifier’s power, select the input source, turn on themonitor TV’s power, turn on the source component’spower and set the source to the play mode, all at thetouch of a single button.2 System call buttons• Up to 12 signals each can be stored at the SYSTEMCALL 1 ~ 6 buttons.• The System Call function can be used in the AMP,ZONE2, ZONE3 and ZONE4 modes.