Denon AVC-A11XV Operating Instructions Manual

Also see for AVC-A11XV: Operating instructions Control protocol Service manual

Contents

Denon AVC-A11XV Operating Instructions Manual Manual pdf 25 page image

ENGLISH22ENGLISHBasic Operation Basic OperationDTS:(exclusive DTS signal playback mode)Decoding and playback are only performed whenDTS signals are being input.Press the ANALOG button to switch to theanalog input.2 Selecting the analog modePCM:(exclusive PCM signal playback mode)Decoding and playback are only performed whenPCM signals are being input.Note that noise may be generated when using thismode to play signals other than PCM signals.ANALOG:(exclusive analog audio signal playback mode)The signals input to the analog input terminals aredecoded and played.NOTE:• Input mode when playing DTS sources:Noise will be output if DTS-compatible CDs orLDs are played in the “ANALOG” or “PCM”mode.When playing DTS-compatible sources, be sureto connect the source component to the digitalinput terminals (OPTICAL/COAXIAL) and set theinput mode to “DTS”.2 Input mode display• In the AUTO mode• In the DIGITAL PCM mode• In the DIGITAL DTS mode• In the ANALOG modeDepending on the input signal.• In the EXT.IN modeFlat:This the frequency response of all speakers flat.This is suitable for multi-channel music reproduction,from discrete music sources such as Dolby Digital5.1, DTS, DVD-Audio and Super Audio CD.Room EQ function Press the ROOM EQ button.• The “Audyssey” is selected, the MultEQ XTindicator lights green.• The “Front” or “Flat” is selected, the MultEQ XTindicator lights red.The Room EQ switches as follows each time theROOM EQ button is pressed.OFF Audyssey Front Flat ManualThe MultEQ XT indicator also lights red if the“Speaker Configuration”, “Delay Time”,“Channel Level” or “Crossover Frequency” isset manually after conducting the Auto Setupprocedure.The AVC-A11XV’s Auto Setup / Room EQ functionoffers three correction curves: “Audyssey”, “Front”,“Flat”. The timbre of the speakers can also beadjusted manually using a graphic equalizer.Details of the different correction curves are describedbelow.Audyssey:This adjusts the frequency response of all speakersto correct the effects of room acoustics.Front:This adjusts the characteristics of each speaker tothe characteristics of the front speakers.Manual:Selects the setting value that was set in the ManualEQ Setup.For details of the “Setting the Manual EQ Setup”( page 48).2 Input signal display• DOLBY DIGITAL• DTS• PCM Depending on the input signal.• The “HDCD” indicator lights whendigital signals are being input with aplayer that supports HDCDplayback.Depending on the input signal.• The “DSD” indicator lights whenthe DENON LINK or IEEE1394have been connected and the DSDsignals have been inputted (page 16, 17).The “DIG.” indicator lights when digital signals arebeing input properly. If the “DIG.” indicator doesnot light, check whether the digital inputcomponent setup ( page 42) and connectionsare correct and whether the component’s power isturned on.AL24 processing is activated when PCM signalsare played while the surround mode is set to PUREDIRECT, DIRECT, STEREO, MULTI CH PUREDIRECT, MULTI CH DIRECT or MULTI CH IN.NOTE:• The “DIG.” indicator will light when playing CD-ROMs containing data other than audio signals,but no sound will be heard.• The “Audyssey”, “Front” and “Flat” Room EQcurves can be selected after performing the AutoSetup procedure.ROOM EQROOM EQ