Denon AVP-A1HD Owner's Manual

Also see for AVP-A1HD: Product Compatibility Chart Owner's manual Owner's manual Owner's manual Brochure & specs

Contents

Denon AVP-A1HD Owner's Manual Manual pdf 31 page image

Getting Started Connections Playback Remote Control Multi-Zone Information Troubleshooting SpecificationsError MessagesIf the auto setup procedure could not be completed due to speaker installation, the measuring environment, etc., an error message isdisplayed. If this happens, check the relevant items, be sure to take the necessary measures, then perform the auto setup procedure overagain.Error messages (examples) Cause MeasuresNo microphone or speaker • Included setup microphone is not connected.• Not all speakers could be detected.• The front L speaker was not properly detected.• Connect the included setup microphone to the SETUPMIC jack on the main unit.• Check the speaker connections.Ambient noise is too highor Level is too low• Too much noise in the room for accuratemeasurements to be made.• Speaker or subwoofer sound is too low foraccurate measurements to be made.• Either turn off any device generating noise or move itaway.• Try again when the surroundings are quieter.• Check the speaker installation and the direction in whichthe speakers are facing.• Adjust the subwoofer’s volume.None • Displayed speaker could not be detected.· The front R speaker was not properly detected.· Only one channel of the surround (A) andsurround (B) speakers was detected.· Sound was output from the R channel when onlyone surround back speaker was connected.· The surround back or the surround (B) speakerwas detected, but the surround (A) speakerwas not detected.· When the subwoofer configuration is set at“2SP L/R”, “2SP MIX”, “3SP L/R/LFE” or “3SPMIX”, the subwoofer could not be detected.• Check the connections of the displayed speaker.Phase • Displayed speaker connected with the polaritiesreversed.• If the XLR pre-out terminal is used, the polarity isreversed.• Check the polarities of the displayed speaker.• Check the polarity setting for the XLR output of thedisplayed pre-set channel.• For some speakers, this error message may be displayedeven if the speaker is properly connected. If you are surethat the wiring is correct, select “Skip”.Room EQSelect room EQ setting method.[Selectable items] All Assigns OptionSelect settings for room EQ, mic, etc.Direct ModeSelect room EQ use for DIRECT or PURE DIRECT mode.[Selectable items] ON OFFMic SelectSelect the microphone type if not using supplied mic.The microphone connected to V.AUX Lch is used.[Selectable items] Mic V.AUX LNOTE Be sure to turn the power off before checking the speaker connections.Select “Retry” to make the measurements again.Only a professionally certified installer should ever connect aprofessionally-calibrated microphone to the V.AUX L input on the frontpanel.• Sometimes due to the electrical complexities of subwoofers and the interaction with the room, THX recommends setting the level and thedistance of the subwoofer manually.• Sometimes due to interaction with the room, you may notice irregular results when setting the level and/or distance of the main speakers. Ifthis happens, THX recommends setting them manually.• Please note that any THX main speakers should be set to Small (80 Hz). If you set up your speakers using Auto Setup, please make suremanually that any THX speakers are set to Small with 80 Hz crossover.d Parameter CheckCheck auto setup measurement results.This is displayed after the auto setup procedure iscompleted.[Selectable items]Spkr Config Check Distance Check Ch. Level CheckCrossover Check EQ Check RestoreThe auto setup results can be reset to what was originally calculatedby MultEQ XT when “Restore” is selected.Setup