Denon AVP-A1HD Owner's Manual

Also see for AVP-A1HD: Product Compatibility Chart Owner's manual Owner's manual Owner's manual Brochure & specs

Contents

Denon AVP-A1HD Owner's Manual Manual pdf 65 page image

Getting Started Connections Setup Remote Control Multi-Zone Information Troubleshooting Specifications1 Either turn or press [SAT TU](AMP mode) to select “XM”.: ”Source Select” (vpage 45)2 To operate using the main remote control unit, set theremote control unit to the TUNER ( ) mode.(vpage 77 “Remote Control Unit Operations”)3 Use [d f] to select the channel.When the channel is tuned in, the name of the song and artistare displayed.• The channel switches continuously when [d f] is pressed and held.• XM Radio channels can be preset using the same procedure as forFM/AM stations (vpage 59, 60 “Presetting Radio Stations (PresetMemory)” and “Listening to Preset Stations”).• The artist name, song title, category and reception level can bechecked by pressing .• The time for which the GUI menus are displayed can be set atGUI menu “Manual Setup” – “Option Setup” – “GUI” – “Tuner”(vpage 42).Basic Operation Checking the XM Signal Strength andRadio ID1 Either turn or press [SAT TU](AMP mode) to select “XM”.2 Press until “SIGNAL” appears on thedisplay.The display will switch as shown below, depending on thereception conditions.Display GUI StatusGOOD Signal strength is goodMARGINAL Signal strength is marginalWEAK Signal strength is weakNO No signal3 Adjust the position of the antenna until “SIGNAL:GOOD” is shown on the display.4 Press until the channel (example:“XM001”) is displayed.5 Press [d f] and select channel 0 (XM000).The radio ID is shown on the display.The strength of both the XM satellite and terrestrial signals can bechecked at GUI menu “Source Select” – “XM” – “Antenna Aiming”(vpage 49).Radio IDAccessing XM Radio Channels Directly1 Press [SEARCH].2 Press [NUMBER] then input the channel.Example: Accessing channel “XM123”:[1] → [2] → [3]b If no button is pressed within several seconds, the channelautomatically switches to the one whose number has been input.3 Press ENTER to set that channel.Reception switches to the selected channel.• “LOADING” is displayed while channels or data are being received.• “XM - - -” is displayed if the selected channel cannot be used.Searching Categories1 Press o p.2 Use o p to select the category, then use ui to selectthe desired channel.Channel categoryPlayback