Denon AVR-3806S Operating Instructions Manual

Also see for AVR-3806: Capabilities and Compatibilities Guide Specifications Supplementary guide Code List Service manual

Contents

10Easy Setup and Operation Easy Setup and OperationConnecting a microphone1 Connect the microphone for Auto Setup to theSETUP MIC jack on the front panel of the unit.2 Mount the auto setup microphone onto a cameratripod, etc., and place it at ear height at the mainlistening position in the listening room with thesound receptor facing the ceiling.MicrophoneNOTE:• Do not disconnect the microphone until the settings arecompleted.• Do not change the connection of speakers or thesubwoofer’s volume after performing these measurements.When placing the microphone, adjust the height so that themicrophone’s sound receptor is at the height of the ears ofthe listener.Be sure that at the beginning, the measurement is startedwith the microphone set up at the main listening position.It is not possible to measure properly if there are anyobstacles between the speakers and microphone. Checkthat there are no obstacles.Please do not stand between or near the speakers and themicrophone during the measurements.ENTERONOFFCURSORSYSTEMSETUPAMPON/STANDBYSYSTEM SETUPCURSORPOWER ENTER SETUP MIC4 Press the ON/STANDBY switch on the main unitor ON button on the remote control unit.• When pressed, the power turns on and the display lights.• When pressed again, the power turns off, the standbymode is set and the display turns off.3 Press the POWER switch.£ OFF:The power turns off and the indicator is off.In this position, the power cannot be turned on and off fromthe remote control unit.¢ ON:The power turns on and the indicator lights.Set the POWER switch to this position to turn the power onand off from the included remote control unit.1 Turn on your subwoofer.Turn on your monitor (TV).Turning on the power5 Press the AMP button to select the “AMP” mode(only when operating with the remote controlunit ( page 26)).2The sound is muted for several seconds, after which theunit operates normally.When ever the ON/STANDBY button is in the standby state,the apparatus is still connected to the AC line voltage.Please be sure to turn off the POWER switch or unplug thecord when you leave home for, say, a vacation.Set the volume to halfway and set the crossover frequencyto the maximum or Low pass filter off if your subwoofer canadjust the output volume and the crossover frequencySome subwoofers have a standby mode. Be sure to turnthis function off before performing the Auto Setupprocedure.