56Advanced Operation Advanced Operation• When the outputs of the “ZONE2 (ZONE3)” OUT terminals are wired and connected to power amplifiers installed in other rooms,different sources can be played in rooms other than the MAIN ZONE in which this unit and the playback devices are installed. (Referto ZONE2 (ZONE3) on the diagram below.)• Settings can be made at “Power Amp Assign” in the “System Setup Menu” so that the same source as the ZONE2 (ZONE3) pre-out terminals can be played from the speakers connected to the ZONE2 (ZONE3) speaker terminals ( page 72).• When a sold separately room-to-room remote control unit (DENON RC-616, 617 or 618) is wired and connected between the MAINZONE and ZONE2 (ZONE3), the remote-controllable devices in the MAIN ZONE can be controlled from ZONE2 (ZONE3) using theremote control unit.To control playback devices other than the ones above, either use that device’s remote control unit or preset a separately soldprogrammable remote control unit.Multi zone music entertainment system• For instructions on installation and operation of separately sold devices, refer to the devices’ operating instructions.Multi-zone playback using the ZONE2 and ZONE3 PREOUT terminals2 When using the power amplifier as the MAIN ZONE output• The AVR-3806 is equipped with pre-out terminals for which the volume is adjustable and video output terminals (composite and S-Video) as the ZONE2 output terminals, and fixed output level as the ZONE3 output terminals.[System configuration and connections example]Using external amplifier.AVR-3806DVD playerInputRC-616MonitorMAIN ZONE 7.1-channel systemZONE2 AUDIO OUT(VARIABLE OUT)SYSTEM REMOTECONTROL UNIT RC-1024ZONE3 AUDIO OUT (FIXED OUT)PROGRAMMABLEREMOTE CONTROL UNITRC-617 RC-617PROGRAMMABLEREMOTECONTROL UNITZONE2VIDEO OUTCFL FRSLSWSRBSBRSBLBPremainAmpliferPowerAmpliferZONE 2 ZONE 3Monitor: MULTI SOURCE AUDIO signal cable: MULTI SOURCE VIDEO signal cable: ROOM-TO-ROOM REMOTE CONTROL SYSTEM(separately sold) control lineRefer to “Connections” ( page 24).