24Connecting Other Sources Connecting Other SourcesFor instructions on operations using the MULTI ZONE functions ( page 56~58).Connecting the MULTI ZONE terminals• If another power amplifier or pre-main (integrated) amplifier is connected, the ZONE2 pre-out(variable) and ZONE3 pre-out (fixed level) terminals can be used to play a different programsource in ZONE2 (or ZONE3) the same time ( page 56).• The ZONE2 video out is only for the ZONE2.• When a sold separately room-to-room remote control unit (DENON RC-616, 617 or 618) is wiredand connected between the MAIN ZONE and ZONE2 (ZONE3), the remote-controllable devicesin the MAIN ZONE can be controlled from ZONE2 (ZONE3) using the remote control unit.ZONE2 (or ZONE3) pre-out connectionsNOTE:• For the AUDIO output, use high quality pin-plug cables and wire in such a way that there is nohumming or noise.• For instructions on installation and operation of separately sold devices, refer to the devices’operating instructions.• When the surround back’s power amplifier is assigned to the ZONE2 or ZONE3 output channelat “Power Amp Assign” in the “System Setup Menu”, the surround back speaker terminals canbe used as the ZONE2 or ZONE3 speaker out terminals ( page 57).• The connections diagram below is an example for when the surround back speaker is assignedto the ZONE2 stereo 2 channel.In this case, surround back speaker out can not be used for MAIN ZONE.ZONE2 / ZONE3 speaker out connectionsPower amplifier(ZONE2)Premain amplifier(ZONE3)RLINMonitor TV(ZONE2)S VIDEOINVIDEOINAUX OUTRLRLHAG++RC-617INFRAREDSENSORRC-616INFRAREDRETRANSMITTERINPUT OUTPUTExtension terminalfor future use.Monitor TV(ZONE 2)Power amplifier(ZONE 2)Premain amplifier(ZONE 3)> <> <> < > <> <> < > <> < > <IN(R)(L)(L) (R)(L) (R)(L) (R)Connectionterminal forsubwooferwith built-inamplifier(subwoofer),etc.Surroundspeakersystems (A)SubwooferSurroundspeakersystems (B)ZONE2Front speakersystemsFront speakersystemsCenterspeakerZONE2