Denso GT10Q-SR User Manual

Also see for GT10Q-HR: Operator's manual

Contents

11Chapter 7 Scanning Functions7.1 Data Verification modeThe Data Verification mode verifies the code data read against the master data stored in the scanner and reports the matchstatus with data output. You can set the verification parameters with the configuration software.There are two ways to register master data--"Preset master registration" and "Scanning master registration." The formerrefers to registration that you make with the configuration software in advance; the latter can be made by scanning a codelabel.7.1.1 Verification setup procedure(1) Preset master registrationRegister the code type and data to be used for verification using the configuration software. Up to 99 digits can beregistered. The registered data will be sent to the host PC when you scan the "Output master data code" given on page 13.The registered master data will be preserved even if the scanner is turned off. To clear it, first clear the registered masterdata stored in the host PC with the configuration software and then send the new setting data to the scanner.(2) Scanning master registrationScan a code to be registered as master data in the following way:1) Place the scanner in the Data Verification mode and hold down the magic key for approx. 2 seconds. (The indicatorLED should light in green.)2) With the magic key held down, press the trigger switch to read the master code to be registered. (The scanner operatesin the trigger switch operating mode currently set.)During the registration operation above, if the master data has fewer characters than specified (e.g., less than the specifiedverification start position), the registration operation aborts with an error.Even if "Preset master registration" has been made, you can make "Scanning master registration." If both "Preset masterregistration" and "Scanning master registration" have been made, the number of characters to be verified that has been setwith the "Preset master registration" and the master data that has been set with the "Scanning master registration" will bevalid.The registered data will be sent to the host PC when you scan the "Output master data code" given on page 13.NOTE: The registered master data will be cleared when:- the scanner is turned off,- you change the parameters of the verification start position or the number of characters to be verified, or- the verification conditions are updated with the configuration software, by scanning a batch-process QR code, orby scanning the QR-coded parameter menu.NOTE: You can register a code as master data any number of times as long the indicator LED is lit in green by pressing themagic key. The code that is read last becomes the final master data.NOTE: If no master data has been registered by either the preset master registration or scanning master registration, theindicator LED flashes in red, during which it is impossible to scan codes.