Denso GT10Q-SR User Manual

Also see for GT10Q-HR: Operator's manual

Contents

338.3 VibratorThe vibrator offers three configuration choices: indicating successful scanning (OK), indicating an error (NG), anddisabled.The OK setting uses the vibrator to indicate the following.- Successful transmission of the bar code data just read- In data verification mode, a match between the bar code data just read and a master data entry- In data verification mode, successful entry of master data- Scanning of a split QR code- In batch edit mode, successful transmission of a split QR code sequence- End of data transmission started by the retransfer or specific character transfer function- Change in list of readable codes- Scanning of "Start setting," "End setting," or parameter setting code from the QR-coded parameter menu (given inChapter 12)- Start or end of parameter setting with the configuration software- Scanning of a batch-process QR code generated with the configuration softwareThe NG setting uses the vibrator to indicate the following.- Wrong number of digits in data for new master data entry- In data verification mode, failure to find a match in the master data for the bar code data just read- In edit mode, a split QR code sequence containing over 8 kilobytes of data- Failure to find a match in the master data for the split QR code sequence just read- Detection of a code other than a parameter setting one during a parameter setting sequence using the QR-codedparameter menu- Data transmission failure: CTS at "L" level- No ACK response received in the ACK/NAK mode- Invalid control command (See Appendix 2)- No data to resend (See the data retransfer function in Chapter 6)- Timeout or other communications error during parameter setting with the configuration software