Eaton 9130 User Manual

Also see for Powerware 9130: User guide User guide Specifications User guide Installation guide

OperationEaton 9130 700/3000 VA UPS User’s Guide 164201718—Rev 7 www.eaton.com/powerquality 27Changing the LanguagePress and hold the first button on the left for approximately three seconds to select the language menu. Thisaction is possible from any LCD menu screen.Display FunctionsAs the default or after 15 minutes of inactivity, the LCD displays the start screen.The backlit LCD automatically dims after 15 minutes of inactivity. Press any button to restore the screen.Press any button to activate the menu options. Use the two middle buttons ( and ) to scroll through the menustructure. Press the Enter (( ) button to select an option. Press the ESC button to cancel or return to theprevious menu.Table 2 shows the basic menu structure.Table 2. Menu Map for Display FunctionsMain Menu Submenu Display Information or Menu FunctionUPS Status Main status (mode and load) / Notice or Alarm status (if any) / Batterystatus (state and charge level)Event Log Displays up to 127 events and alarmsThe Event Log is also available through the serial port. See ”Retrieving theEvent Log”on page 33.Measurements Load W VA / Load A pf / Output V Hz / Input V Hz / Bypass V Hz / Input LineEvents / Battery V minControl Go to Bypass Transfers the UPS system to internal Bypass modeWhen this command is active, the option changes to “Go to Normal.”Start Battery Test Starts a manual battery testSee ”Testing New Batteries”on page 52.Reset Error State Clears a “Battery Test Failed”alarmLoad Segments Load segment 1: ON | OFFLoad segment 2: ON | OFFThese commands overrule user settings for load segments. See“Configuring Load Segments”on page 35.Restore Factory Settings Returns all settings to original values only after UPS is powered down.The following settings do not change:"Output voltage setting"Site wiring fault alarm"REPO terminal setting"Serial number"Part numberIdentification UPS Type / Part Number / Serial Number / FirmwareSettings User Settings See Table 3 for details.Service Settings This menu is password-protected.