Eaton Cooper Power Series Installation And Operation Instruction Manual

Also see for COOPER POWER SERIES: Installation and operation instructions Installation instructions Installation instructions Installation and operation instructions Operation instructions

Eaton Cooper Power Series Installation And Operation Instruction Manual Manual pdf 17 page image

CommunicationsCommunication portsThe Form 4D control has a front panel configurationdata port and provisions for two optional side-panelcommunication ports (Figure 10).The front panel configuration data port is described in theOperating Panel section of this manual.There are two standard USB ports (one host and one client),as well as any two of the following: RS-232, RS-485, Serialfiber, Ethernet wire, Ethernet fiber (MTRJ Multi-mode, SCMulti-mode, ST Multi-mode, and LC Single-mode).Communication protocolsSeven native communication protocols are available for theForm 4D recloser control:Serial protocols●● DNP3●● 2179●● MODBUS●● IEC 60870-5-101Ethernet protocols●● DNP3 TCP/IP●● MODBUS TCP/IP●● IEC 70870-5-104Any available communication protocol can be selectedand configured by the user with the ProView NXGapplication software.DNP3 is factory-defaulted to the communication ports onthe side panel.Ethernet Communications●● ProView NXG over TCP/IP.●● DNP3 IP.●● IEC60870-5-104.Ethernet connection allows for network application of theForm 4D pole-mount control for both DNP3 and ProViewNXG protocols. In addition, the front panel data port cansimultaneously communicate ProView NXG to the PC.Ethernet configuration is accomplished via ProView NXGinterface software. Refer to S280-104-2 Form 4D ControlProgramming Guide for Ethernet Configuration information.The user can simultaneously communicate to the Form4D control using both the front panel data port and theappropriate side panel communication port.Control informationControl information includes firmware identification bycatalog number and name, date code, and ProView NXGrelease number. Control information is available through theNAMEPLATE DATA menu on the front panel (Figure 4).Control side panelThe control side panel is easily accessible when the swing-panel of the control cabinet is opened.Port 1:RS-232 SerialCommunicationsoptionPort 2:Serial Fiber, STCommunica-tionsFigure 10. Form 4D Pole-mount recloser controlcommunication port identificationInstallation procedureInitial programming prior to installationCAuTIONEquipment misoperation. Do not connect this controlto an energized recloser until all control settings havebeen properly programmed and verified. Refer to theprogramming information for this control. Failure tocomply can result in control and recloser misoperation,equipment damage, and personal injury. g110.3CAuTIONLoss of protection. Reconfigure the user settings. Whenthe CONTROL OK LED is flashing, control protectionis disabled. user protection profile settings must bereconfigured to enable protection. Loss of protection canresult in personal injury and equipment damage. T360.112 operation inStrUCtionS MN280049EN September 2017Form 4D Microprocessor-based pole-mount recloser control installation and operation instructions