Eaton Cooper Power Series Installation And Operation Instruction Manual

Also see for COOPER POWER SERIES: Installation and operation instructions Installation instructions Installation instructions Installation and operation instructions Operation instructions

Eaton Cooper Power Series Installation And Operation Instruction Manual Manual pdf 19 page image

Using Table 2, select the appropriate recloser interruptingduty cycle factor and enter that value via the ProView NXGinterface software.Table 2. Duty cycle factor.Recloser typeInterrupting rating(rms sym Amps)100% Duty cyclefactor*WE 12,000 @ 4.8 kV 257WE 10,000 @ 14.4 kV 196VWEVWVE27VWVE38X12,000 1045WVE27 8,000 140WVE38X 8,000 140VSA12 12,000 1045VSA16 16,000 1608VSA20VSA20A 20,000 2248VSO12 12,000 1045VSO16 16,000 1608Auxiliary-PoweredNOVA 12,500 111116,000 1608Control-PoweredNOVA 12,500 111116,000 1608*Duty Cycle Factor is Value x 105.Mounting the controlWARNINgThis equipment is not intended to protect humanlife. Follow all locally approved procedures and safetypractices when installing or operating this equipment.Failure to comply may result in death, severe personalinjury and equipment damage. g102.1Mount the Form 4D pole-mount recloser control in aconvenient, accessible location. Mounting dimensions areprovided in Figure 11.otee:N Unless otherwise specified, dimensions shown ininches.A hole and keyway in the control mounting bracketaccommodates a 12 mm (0.50”) diameter bolt.IMPORTANTWhen opened, both the cabinet door and the insideswing-panel door lock into the open position. Lift thedoor or swing-panel up to raise the hinge out of thelocking position prior to closing the inside swing-paneldoor or the cabinet door. Instructions are indicated onthe inside of the cabinet door.20.191.45PROVISIONS FORUP TO 5/8"MOUNTING HARDWARE.QUARTER TURNLATCH WITHPADLOCKPROVISIONSRECOMMEND TOUSE THE SMALLDIAMETER HOLE(0.320 inch)QUARTER TURNLATCHGROUND LUG FOR#6 to #14 SOLID ORSTRANDED WIRELASER CUTVENT OPENINGSOPENINGS FOR OPTIONAL RECEPTACLESUNDER STAINLESS COVERS, ACCESSABLE ONLY FROMINSIDE OF CABINETFOR RADIO ANTENNARECEPTACLECONTROLPOWERINPUTRECEPTACLEFOR RECLOSERCONTROL CABLE21.9418.0013.40 1.2515.071.13 LIFTINGLUGFigure 11. Form 4D Pole-mount recloser control weights and dimensionsCONTROL WEIGHT: 29 kg(63 lbs.) without battery8 AH BATTERY WEIGHT: 6 kg(13 lbs.)13 AH BATTERY WEIGHT: 10kg (24 lbs.)(All weights are approximate.)14 operation inStrUCtionS MN280049EN September 2017Form 4D Microprocessor-based pole-mount recloser control installation and operation instructions