Eaton Power Xpert Solar 1500 User Manua

Installation InstructionsPower Xpert Solar 1500/1670 kW Inverter MN141001EN—October 2014 www.eaton.com 13Installation InstructionsConnect the Power Xpert Solar 1500/1670 kW Inverter to thephotovoltaic array and utility per the NEC, ANSI/NFPA70requirements. Additional utility and local codes may alsoapply. Following the inverter-specific instructions will ensureoptimum performance, longevity, and warranty retention.Contact Eaton if there are any questions.DANGER of Electric Shock HazardWARNING!NOTICE!Delivery InspectionThe Power Xpert Solar 1500/1670 kW Inverter undergoesscrupulous tests and quality checks at the factory beforedelivery. There remains however the possibility of damageduring shipment. Upon receiving and unpacking the inverter,verify no damage is found on or inside the product and thatthe delivery is complete. If the inverter has been damagedduring shipping, please contact the carrier and cargoinsurance company. If the delivery does not correspond toyour order, contact the supply-chain seller immediately.Note: Shipping damage typically must be declared at thetime of delivery.Verify the shipping carrier’s terms before thescheduled delivery.Figure 9. Mounting of Lifting BracketsUnloading and Moving ProcedureThe inverter can be transported locally by crane or forklift.Direct Crane from the delivery-truck to inverter pad is highlyrecommended and efficient. Typical unloading, in thismanner, is under an hour. Note: The transformer is similar,yet cannot be transported by forklift without a pallet. Theinverter is delivered with 4 lifting-brackets per (delivery) site.Re-use these brackets when multiple inverters are deliveredto any one location.If additional brackets are required, please consult your salesrepresentative.● Rigging must attach to the 4 lifting-brackets on the frontand back of the inverter.● Select appropriate spreading bar and straps to preventdamage● Do not cross-thread the bolts and inverter-threadsapplicable to the lifting-brackets (Refer to Figure 9)● Fork access is in the center of the Power Xpert SolarInverter● The fork-pockets are accessible from either the front orthe back● Verify that the lifting-means used is rated for the weight ofthe entire assembly.● Moving and Lifting Instructions are as shown in Figure 11and Figure 12.Once installed, be sure to cover the inverter’s forklift openingwith the provided steel covers. Refer to Figure 10.Figure 10. Mounting of Cover PlatesTable 4. Mounting12341 2 3 4Lifting Brackets Cover Plates1 Lift Tab Opening Cover Plate2 5/8 Flat Plain Washer 5/8 Flat Plain Washer3 5/8 Spring-Lock Washer 5/8 Spring-Lock Washer4 5/8-11 x 2.5 Hex Cap Head Grade 5 Machine Screw 5/8-11 x 1.5 Hex Cap Head Grade 5 Machine Screw