Eaton Rapid Link 5 Manual

Also see for Rapid Link RAMO5: Manual

6 RASP5 speed controller6.7 Configuration of specific settingsRapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com 1496.7.4 Quick stop and interlocked manual operationTable 27: Settings for parameter P1-13, “SEN Config Select”P1-13 Description0 Reserved1 No add-on functions (as supplied)2 Quick stop: Automatic mode onlySEN I1 and SEN I2 activated. SEN I1 is assigned to the clockwise direction of rotation,SEN I2 is assigned to the counterclockwise direction of rotation:Application example: Vertical sorter < 360° eccentric3 Quick stop: Automatic mode onlySEN I1 activated. SEN I1 is assigned to both directions of rotation. SEN I2 has no additional function.Application example: Chain ejector4 Quick stop and interlocked manual mode (edge- and signal-controlled):SEN I1 and SEN I2 activated. SEN I1 is assigned to the clockwise direction of rotation, SEN I2 is assi-gned to the counterclockwise direction of rotation;Application example: Vertical sorter < 360° eccentricNote:In automatic mode, only edge-controlled5 Quick stop and interlocked manual mode (only edge controlled):SEN I1 and SEN I2 activated. SEN I1 and SEN I2 are assigned to the clockwise direction of rotation.The operating direction "left" is blocked:Application example: Vertical sorter > 360° eccentric and > 360° turntable6 Quick stop and creep speed: In automatic modeSEN I1 to SEN I4 are activated. SEN I1 and SEN I3 are assigned to the clockwise direction of rotation;SEN I2 and SEN I4 are assigned to the counterclockwise direction of rotation. When SEN I3/SEN I4 isreached, RASP5… switches to creep speed FF1. When SEN I1/SEN I2 is reached, the drive switches off(edge-controlled and signal-controlled).Application example: TurntableNote:SEN I3 and SEN I4 require a RA-XM12-Y Y connector.7 Quick stop and creep speed: In automatic modeSEN I1 to SEN I4 are activated. SEN I1 and SEN I3 are assigned to the clockwise direction of rotation;SEN I2 and SEN I4 are assigned to the counterclockwise direction of rotation. When SEN I3/SEN I4 isreached, RASP5… switches to creep speed FF1. When SEN I1/SEN I2 is reached, the drive switches off.Application example: TurntableSEN I1 and SEN I2: edge-controlledSEN I3 and SEN I4: edge-controlled and signal-controlledNote:SEN I3 and SEN I4 require a RA-XM12-Y Y connector.8 Quick stop and interlocked manual mode (edge- and signal-controlled) and creep speed:SEN I1 to SEN I4 are activated. SEN I1 and SEN I3 are assigned to the clockwise direction of rotation,SEN I2 and SEN I4 are assigned to the counterclockwise direction of rotation. When SEN I3/SEN I4 isreached, RASP5… switches to creep speed FF1. When SEN I1/SEN I2 is reached, the drive switches off.Application example: TurntableNote:SEN I3 and SEN I4 require a RA-XM12-Y Y connector.