Eaton Rapid Link 5 Manual

Also see for Rapid Link RAMO5: Manual

8 Parameter list8.4 Parameter groups for RASP5Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com 1818.4.3 Parameter group 2 (Extended functions)Table 42: Parameter group 2 (Extended functions)Parameter Designation Description Unit Min Max DSP2-01 f-Fix2 Preset Fixed Frequency 2Value can be adjusted between f-min and f-max.Selection via a digital control signal.Hz/rpm P1-02 P1-01 30 HzP2-02 f-Fix3 Preset Fixed Frequency 3Value can be adjusted between f-min and f-max.Selection via a digital control signal.Hz/rpm P1-02 P1-01 40 HzP2-03 f-Fix4 Preset Fixed Frequency 4Value can be adjusted between f-min and f-max.Selection via a digital control signal.Hz/rpm P1-02 P1-01 50 hzP2-04 f-Fix5 Preset Fixed Frequency 5Value can be adjusted between f-min and f-max.Selection via a digital control signal.Hz/rpm P1-02 P1-01 10 hzP2-05 f-Fix6 Preset Fixed Frequency 6Value can be adjusted between f-min and f-max.Selection via a digital control signal.Hz/rpm P1-02 P1-01 15 HzP2-06 f-Fix7 Preset Fixed Frequency 7Value can be adjusted between f-min and f-max.Selection via a digital control signal.Hz/rpm P1-02 P1-01 20 hzP2-07 f-Fix8 Preset Fixed Frequency 8Value can be adjusted between f-min and f-max.Selection via a digital control signal.Hz/rpm P1-02 P1-01 25 HzP2-08 t-SRamp1 Curve shape, temporal S-shapeLinear acceleration and deceleration time according to P1-03and P1-04.Timed slurred Transition to Start and End of Acceleration(P1-03) and Deceleration Ramps (P1-04).The time set here applies for both ramps.0.0 = linears 0 10 0P2-09 Overvoltage control The overvoltage control prevents the drive from tripping incase of regenerative energy feedback from the motor to theDC link.When disabled, the drive will trip “Over Voltage” instead ofautomatically increasing the motor ramp times.- 0 1 1P2-10 REV Enable Activates or deactivates reverse rotation of the motor0: 0: REV activated - motor is running forward and in reverse1: REV deactivated - motor will only run forward- 0 1 0P2-11 t-acc2 Sets the acceleration ramp time 2 in seconds s 0 3000 5.0P2-12 n-accMulti1 Frequency / speed, at which the acceleration ramp changesfrom t-acc1 to t-acc2.This can be set to any value between 0 and “f-max” (P1-01)“Motor Nom Speed” (P1-10) = 0, displayed in Hz.“Motor Nom Speed” (P1-10) > 0, displayed in rpm.Frequency / Speed > P2-12 = t-acc2Frequency / Speed < P2-12 = t-acc1Hz/rpm 0 P1-01 0P2-13 t-dec2 Sets the deceleration ramp time 2 in seconds.Activation via pin 4 at AS-i.s 0 3000 5.0