Web Interface OperationEaton ePDU G3 Operation Manual P-164000277—Rev 5 106Configure the IPv4 Settings1. Access the Web interface and log in.2. Under Network, select TCP/IP. The TCP/IP page displays.3. In the IPv4 panel, select the manner by which IPv4 settings are configured from the BootP/DHCPdrop-down list:l Enabled. The IPv4 settings are configured by the DHCP server. If DHCP is enabled, go to Step 5.l Disabled. The IPv4 settings are manually configured by the user. If DHCP is disabled, perform thefollowing:- Type the IPv4 address.- Type the IPv4 subnet mask.- Type the IPv4 address of the gateway (if any).- Type the ePDU host name (used for DNS resolution).- Type the ePDU domain name (used for DNS resolution)4. Click Save.5. Open the System page. In the Network Management Card panel, click Restart network managementcard to restart the ePDU Network Management and Control (eNMC) module. A pop-up confirmationmessage displays:Are you sure you want to restart the Network Management Card?Note: This will NOT restart the ePDU or change the power status of the outlets.Configure the IPv6 Settings1. Access the Web interface and log in.2. Under Network, select TCP/IP. The TCP/IP page displays.3. In the IPv6 panel, enable the IPv6 interface by checking the IPv6 Enabled check box.4. Select one of the following configuration methods for IPv6 settingsl For manual configuration, uncheck the IPv6 Address Auto Configuration Enabled check box. Continueto Step 5.l For auto configuration, check the IPv6 Address Auto Configuration Enabled check box. Continue toStep 10.5. Type the local IPv6 address.6. Type the prefix length for the global IPv6 address.NOTE By default, the IPv6 interface is disabled. You can enable it from the Web interfaceor the Serial interface.NOTE 1 For manual configuration, provide the IPv6 global address with its prefix length andthe IPv6 address of the gateway (if any).NOTE 2 For auto-configuration, the global IPv6 addresses and prefix lengths areautomatically configured by the network (an IPv6 router is required). The gatewayIPv6 address is defined by the user.NOTE 3 Regardless of the configuration you choose, the local IPv6 address isauto-generated by the eNMC module.
