Eaton ePDU G3 Operating Manual

Also see for ePDU G3: Troubleshooting guide Installation and connection guide Operation manual Manual Installation & quick start guide

Contents

InstallationEaton ePDU G3 Operation Manual P-164000277—Rev 5 22Using Clip Feet and Cage Nuts on a Square-hole RackTo install the ePDU with clip feet secured by cage nuts:1. Locate the cage nuts (supplied).2. Are you mounting the ePDU in line with the rail or away from the rail (offset)?l If in line with the rail, go to Step 3.l If away from the rail, go to Step 5.3. ePDU in line with the rail. Position and lock two cage nuts far enough apart to stabilize the top andbottom of the ePDU when mounted on the rail. Insert the cage nuts with a flat-blade screwdriver (seeFigure 19).4. Locate the two clip feet and four M6 screws (supplied). Position one mounting clip foot at a cage nut andsecure the mounting clip foot to the rail with a screw. Repeat for the second mounting clip. Tighten thescrews. Go to Step 8.Figure 19. Attaching the Clip Feet and Cage NutsNOTE You can install the mounting clip feet vertically or horizontally.NOTE If a square-hole rack is used, cage nuts must be installed. Use a cage nut insertiontool or a flat-blade screwdriver to install the cage nuts.