Web Interface OperationEaton ePDU G3 Operation Manual P-164000277—Rev 5 1103. The current Energy Wise state value displays in the Status field. Valid states are:l Unknownl Not Initializedl Stoppedl Stoppingl Startingl Startedl Downl Initializingl Upl Activel Requested Shutdown4. For Command, select one of the following from the drop-down list:l Startl Graceful Stopl Off-State Cache Stopl Restart5. Click Save.SecurityEnable/Disable SSL Encryption1. Access the Web interface and log in.2. Under Network and Security, select Global. The Security page displays.3. In the Ports Settings panel, ensure that the HTTP Enable check box is checked and that the associatedHTTP Port number displays.4. Check the Force SSL check box to enable SSL encryption, or uncheck the box to disable it. If enabled, theHTTPS Port entry box is active. Type the port number.5. Click Save.6. Open the System submenu in the Settings menu. In the Network Management Card panel, click Restartnetwork management card to restart the ePDU Network Management and Control (eNMC) module.NOTE With SSL encryption, the Web interface is accessible from https://and the https://[IPv6 address], or both, according to the IP configuration.NOTE When Force SSL is selected, the Web page is only available through HTTPS. If youenter the IP address through HTTP, it will be automatically redirected to HTTPS andyou will receive the following message and a new URL link:The Network Management Card is protected by SSL encryption.Please use the following address(es) to connect to the NetworkManagement Card. https://166.99.224.82
