LCD Interface OperationEaton ePDU G3 Operation Manual P-164000277—Rev 5 626. When the pop-up confirms that the USB is detected, click OK, and then press Enter to return to the MainMenu. (If not confirmed within 10 seconds, the pop-up goes away by itself.)7. Select USB Flash Mode. Click Yes to confirm you want to enter the USB Flash mode. (If there is no actionwithin one minute, the eNMC module exits the USB Flash mode. Remove and reinsert the USB drive toaccess this menu again.) The module restarts.8. Select Upgrade FW and click OK to confirm the upgrade (see Figure 68). The eNMC module gets the filefrom the USB drive.Figure 68. Example Select Upgrade Firmware9. A few seconds after 100% is reached, the eNMC module restarts and then enters in Boot upgrade modeto continue upgrade. The upgrade is finished when eNMC module is restarted. This can take severalminutes (see Figure 69).Figure 69. Example Upgrade in ProgressExitSelect Exit to leave USB Flash Mode.Display SubmenuThe Display submenu allows you to customize settings for LCD contrast and orientation (see Figure 70).On the Settings menu, scroll up or down to highlight DISPLAY. Press ENTER to display the screens to set thevalues for the submenu. After you select the values, press ENTER to set the values as displayed on the screen.Press ESC to return to the previous menu.Figure 70. Example Display Submenu DisplaysDaisy ChainSettingsLCDIPv4FactoryDisplayLanguageESCEnterMain MenuActive AlarmsAlarms HistoryMetersControlePDU InfoMain MenuSettingsEnterESCUSB Flash ModeMain Menu.ExitUSB Flash ModeSave Config.Load ConfigSave eNMC fileLoad eNMC fileUpgrade F/WESCEnterUSB Upgrade F/WCurrent Vers.00.00.0021Main MenuUSB Upgrade F/WCurrent F/Wversion.00.00.0021Upload45 %ESCEnterLoad Config.Save eNMC fileLoad eNMC fileExitUSB Flash ModeSave Config.Upgrade F/WContrast:Orientation:LCD350 °Contrast:Orientation:LCD350°90°180°- 90°0 °90°ESCEnter EnterEnterDisplayDaisy ChainIPv4FactorySettingsDisplayLanguage
