Eaton ePDU G3 Operation Manual

Also see for ePDU G3: Troubleshooting guide Installation and connection guide Manual Installation & quick start guide Operating manual

Contents

Web Interface OperationEaton ePDU G3 Operation Manual P-164000277—Rev 1 www.eaton.com/ePDU 1216. Choose one of the following security levels to be applied to the SNMPv3 user:l Not Set: the SNMPv3 user is not configured and therefore disabled.l Auth Priv: an authentication password and a privacy key are required to access the MIB objects.l Auth No Priv: an authentication password but no privacy key are required to access the MIB objects.l No Auth No Priv: no authentication password or privacy key are required to access the MIB objects.7. Type the authentication password (if required by security level), with 8 to 24 characters allowed.8. Type the privacy key (if required by security level), with 8 to 24 characters allowed.9. Click Save. Otherwise, click Cancel to return to the SNMP Settings page.Access Eaton ePDU MIB Objects (Privileged Access Only)1. Access the Web interface and log in.2. Under Network, select SNMP. The SNMP Settings page displays.3. Click Link to the ePDU Mib.SecurityEnable/Disable SSL Encryption1. Access the Web interface and log in.2. Under Network and Security, select Global. The Security page displays.3. In the Ports Settings panel, ensure that the HTTP Enable check box is checked and that the associatedHTTP Port number displays.4. Check the Force SSL check box to enable SSL encryption, or uncheck the box to disable it. If enabled, theHTTPS Port entry box is active. Type the port number.5. Click Save.6. Open the System submenu in the Settings menu. In the Network Management Card panel, click Restartnetwork management card to restart the ePDU Network Management and Control (eNMC) module.NOTE With SSL encryption, the Web interface is accessible from https://and / or https://[IPv6 address] according to the IP configuration.NOTE When Force SSL is selected, the Web page is only available through HTTPS. If youenter the IP address through HTTP, it will be automatically redirected to HTTPS andyou will receive the following message and a new URL link:The Network Management Card is protected by SSL encryption.Please use the following address(es) to connect to the NetworkManagement Card. https://166.99.224.82