5-32 D30 Line Distance Protection System GE Multilin5.2 PRODUCT SETUP 5 SETTINGS5UR relays implement only the DANP functionality. The RedBox functionality is not implemented.The original standard IEC 62439-3 (2010) was amended to align PRP with the High-availability Seamless Redundancy(HSR) protocol. To achieve this, the original PRP was modified at the cost of losing compatibility with the PRP 2010 ver-sion. The revised standard IEC 62439-3 (2012) is commonly referred to as PRP-1, while the original standard is PRP-0.The UR relays support only PRP-1.The relay implements PRP on two of its Ethernet ports, specifically Port 2 and 3 of the CPU module. Use the previous sec-tion (network port configuration) to configure PRP.PRP is purchased as a separate option. If purchased (valid order code), PRP can be enabled in configuration through asetting available on the network configuration menu, REDUNDANCY, which already has the capability of enabling failoverredundancy. The options on this setting must be changed to accommodate two types of redundancy: failover and PRP.When REDUNDANCY is set to either failover or PRP, the ports dedicated for PRP (Port 2 and 3) operate in redundantmode. In this mode, Port 3 uses the Mac, IP address, and mask of Port 2.g) ROUTINGPATH: SETTINGS PRODUCT SETUP COMMUNICATIONS ROUTING 1(6)A default route and a maximum number of six static routes can be configured.The default route is used as the last choice when no other route towards a given destination is found.Configure the network IP and subnet settings before configuring the routing settings.ADDING AND DELETING STATIC ROUTESHost routes are not supported at present.The routing table configuration is available on the serial port and front panel. This is a deliberate decision, to avoid loss ofconnectivity when remotely configuring the UR.By default the value of the destination field is 127.0.0.1 for all static routes (1 to 6). This is equivalent to saying that thestatic routes are not configured. When the destination address is 127.0.0.1, the mask and gateway must be also kept ondefault values.By default, the value of the route gateway address is 127.0.0.1. This means the default route is not configured.To add a route: IPV4 ROUTING TABLE IPV4 DEFAULT ROUTEMESSAGE IPV4 STATIC NETWORK ROUTE 1↓MESSAGE IPV4 STATIC NETWORK ROUTE 6 IPV4 DEFAULT ROUTEGATEWAY ADDRESS127.0.0.1Range: Standard IPV4 unicast address format IPV4 STATIC NETWORK ROUTE 1RT1 DESTINATION:127.0.0.1Range: Standard IPV4 address formatMESSAGE RT1 NET MASK:255.0.0.0Range: Standard IPV4 subnet mask formatMESSAGE RT1 GATEWAY:127.0.0.1Range: Standard IPV4 unicast address format
