1-14 D30 Line Distance Protection System GE Multilin1.3 ENERVISTA UR SETUP SOFTWARE 1 GETTING STARTED1 1.3.5 CONNECTING TO THE D30 RELAYWhen unable to connect because of an "ACCESS VIOLATION," access Device Setup and refresh the order code for thedevice.1. Open the Display Properties window through the Site List tree as shown. The Display Properties window opens with astatus indicator on the lower left of the EnerVista UR Setup window.2. If the status indicator is red, verify that the Ethernet network cable is properly connected to the Ethernet port on theback of the relay and that the relay has been properly setup for communications (steps A and B earlier).If a relay icon appears in place of the status indicator, than a report (such as an oscillography or event record) is open.Close the report to re-display the green status indicator.3. The Display Properties settings can now be edited, printed, or changed.See chapter 4 in this manual or the EnerVista UR Setup Help File for information about the using the EnerVista URSetup software interface.QUICK ACTION HOT LINKSThe EnerVista UR Setup software has several quick action buttons to provide instant access to several functions that areoften performed when using D30 relays. From the online window, users can select the relay to interrogate from a pull-downwindow, then click the button for the action they want to perform. The following quick action functions are available:• View the D30 event record• View the last recorded oscillography record• View the status of all D30 inputs and outputs• View all of the D30 metering values• View the D30 protection summary• Generate a service report842743A3.CDRCommunications status indicators:Green = OKRed = No communicationsUR icon = report is openQuick action hot linksExpand the site list by double-clickingor selecting the +/– box.NOTE
