K0430 Issue No. 2 10Task KeyThe TASK key is used to set-up the instrument for a number of specific types of test.There are two modes BASIC and ADVANCED and nine other specific types of test whichautomatically configure the instrument on selection from the TASK menu. The tasksavailable under the TASK menu are held on three pages shown below. To select a taskfrom the menu, press the TASK key, position the cursor over the required task and pressthe ENTER key as shown below. Use the right/left cursor keys to switch between pages.Using TASK FunctionsSpecific tasks are selected as shown above. The following diagrams show how toconnect the unit under test (UUT) for each task selectable under the TASK menu.Input and output units, where applicable, can be selected by pressing either the INPUT orOUTPUT keys as shown below.Set UnitsNote: If the four units displayed are not the units required, press SETUP, select SETTINGSand refer to select regular units on page 37.Task Selection
