1-8 F60 Feeder Management Relay GE Multilin1.3 ENERVISTA UR SETUP SOFTWARE 1 GETTING STARTED1 10. Click OK when the relay order code has been received. The new device will be added to the Site List window (orOnline window) located in the top left corner of the main EnerVista UR Setup window.The Site Device has now been configured for Ethernet communications. Proceed to Section c) below to begin communica-tions.b) CONFIGURING AN RS232 CONNECTIONBefore starting, verify that the RS232 serial cable is properly connected to the RS232 port on the front panel of the relay.1. Install and start the latest version of the EnerVista UR Setup software (available from the GE enerVista CD or onlinefrom http://www.GEindustrial.com/multilin.2. Select the Device Setup button to open the Device Setup window and click the Add Site button to define a new site.3. Enter the desired site name in the “Site Name” field. If desired, a short description of site can also be entered alongwith the display order of devices defined for the site. Click the OK button when complete.4. The new site will appear in the upper-left list in the EnerVista UR Setup window. Click on the new site name and thenclick the Device Setup button to re-open the Device Setup window.5. Click the Add Device button to define the new device.6. Enter the desired name in the “Device Name” field and a description (optional) of the site.7. Select “Serial” from the Interface drop-down list. This will display a number of interface parameters that must beentered for proper serial communications.• Enter the relay slave address and COM port values (from the SETTINGS Ö PRODUCT SETUP ÖØ COMMUNICATIONSÖØ SERIAL PORTS menu) in the “Slave Address” and “COM Port” fields.• Enter the physical communications parameters (baud rate and parity settings) in their respective fields.8. Click the Read Order Code button to connect to the F60 device and upload the order code. If an communications erroroccurs, ensure that the EnerVista UR Setup serial communications values entered in the previous step correspond tothe relay setting values.9. Click “OK” when the relay order code has been received. The new device will be added to the Site List window (orOnline window) located in the top left corner of the main EnerVista UR Setup window.The Site Device has now been configured for RS232 communications. Proceed to Section c) Connecting to the Relaybelow to begin communications.c) CONNECTING TO THE RELAY1. Open the Display Properties window through the Site List tree as shown below:
