D-2 F60 Feeder Management Relay GE MultilinD.1 IEC 60870-5-104 APPENDIX DDWhen using an unbalanced link layer, the following ADSU types are returned in class 2 messages (low priority) with theindicated causes of transmission:The standard assignment of ADSUs to class 2 messages is used as follows:A special assignment of ADSUs to class 2 messages is used as follows:5. APPLICATION LAYERTransmission Mode for Application Data:Mode 1 (least significant octet first), as defined in Clause 4.10 of IEC 60870-5-4, is used exclusively in this companionstanadard.Common Address of ADSU:One OctetTwo OctetsInformation Object Address:One Octet StructuredTwo Octets UnstructuredThree OctetsCause of Transmission:One OctetTwo Octets (with originator address). Originator address is set to zero if not used.Maximum Length of APDU: 253 (the maximum length may be reduced by the system.Selection of standard ASDUs:For the following lists, the boxes indicate the following: – used in standard direction; – not used; – cannot beselected in IEC 60870-5-104 standard.Process information in monitor direction<1> := Single-point information M_SP_NA_1<2> := Single-point information with time tag M_SP_TA_1<3> := Double-point information M_DP_NA_1<4> := Double-point information with time tag M_DP_TA_1<5> := Step position information M_ST_NA_1<6> := Step position information with time tag M_ST_TA_1<7> := Bitstring of 32 bits M_BO_NA_1<8> := Bitstring of 32 bits with time tag M_BO_TA_1<9> := Measured value, normalized value M_ME_NA_1<10> := Measured value, normalized value with time tag M_NE_TA_1<11> := Measured value, scaled value M_ME_NB_1<12> := Measured value, scaled value with time tag M_NE_TB_1<13> := Measured value, short floating point value M_ME_NC_1<14> := Measured value, short floating point value with time tag M_NE_TC_1<15> := Integrated totals M_IT_NA_1<16> := Integrated totals with time tag M_IT_TA_1<17> := Event of protection equipment with time tag M_EP_TA_1<18> := Packed start events of protection equipment with time tag M_EP_TB_1<19> := Packed output circuit information of protection equipment with time tag M_EP_TC_1<20> := Packed single-point information with status change detection M_SP_NA_1
