GE Multilin F60 Feeder Protection System 1-51 GETTING STARTED 1.3 ENERVISTA UR SETUP SOFTWARE11.3ENERVISTA UR SETUP SOFTWARE 1.3.1 PC REQUIREMENTSThe faceplate keypad and display or the EnerVista UR Setup software interface can be used to communicate with the relay.The EnerVista UR Setup software interface is the preferred method to edit settings and view actual values because the PCmonitor can display more information in a simple comprehensible format.The following minimum requirements must be met for the EnerVista UR Setup software to properly operate on a PC.• Pentium class or higher processor (Pentium II 300 MHz or higher recommended)• Windows 95, 98, 98SE, ME, NT 4.0 (Service Pack 4 or higher), 2000, XP• Internet Explorer 4.0 or higher• 128 MB of RAM (256 MB recommended)• 200 MB of available space on system drive and 200 MB of available space on installation drive• Video capable of displaying 800 x 600 or higher in high-color mode (16-bit color)• RS232 and/or Ethernet port for communications to the relayThe following qualified modems have been tested to be compliant with the F60 and the EnerVista UR Setup software.• US Robotics external 56K FaxModem 5686• US Robotics external Sportster 56K X2• PCTEL 2304WT V.92 MDC internal modem1.3.2 INSTALLATIONAfter ensuring the minimum requirements for using EnerVista UR Setup are met (see previous section), use the followingprocedure to install the EnerVista UR Setup from the enclosed GE EnerVista CD.1. Insert the GE EnerVista CD into your CD-ROM drive.2. Click the Install Now button and follow the installation instructions to install the no-charge EnerVista software.3. When installation is complete, start the EnerVista Launchpad application.4. Click the IED Setup section of the Launch Pad window.