5-52 F60 Feeder Protection System GE Multilin5.2 PRODUCT SETUP 5 SETTINGS5Figure 5–11: USER-PROGRAMMABLE PUSHBUTTON LOGIC (Sheet 2 of 2)User-programmable pushbuttons require a type HP or HQ faceplate. If an HP or HQ type faceplate was orderedseparately, the relay order code must be changed to indicate the correct faceplate option. This can be done viaEnerVista UR Setup with the Maintenance > Enable Pushbutton command.5.2.15 FLEX STATE PARAMETERSPATH: SETTINGS Ö PRODUCT SETUP ÖØ FLEX STATE PARAMETERSThis feature provides a mechanism where any of 256 selected FlexLogic™ operand states can be used for efficient moni-toring. The feature allows user-customized access to the FlexLogic™ operand states in the relay. The state bits are packedso that 16 states may be read out in a single Modbus register. The state bits can be configured so that all of the stateswhich are of interest to the user are available in a minimum number of Modbus registers. FLEX STATE PARAMETERSPARAMETER 1:OffRange: FlexLogic™ operandMESSAGE PARAMETER 2:OffRange: FlexLogic™ operand↓MESSAGE PARAMETER 256:OffRange: FlexLogic™ operandPushbutton 1LEDInstantaneousreset *OR1. If pushbutton 1 LED control is set to off.2. If pushbutton 1 LED control is not set to off.PUSHBUTTON 1 LED LOGICORANDANDSETTING= Disabled= High PriorityPUSHBUTTON 1 MESSAGE= NormalFLEXLOGIC OPERANDPUSHBUTTON 1 ONPushbutton 1LEDSETTING= any FlexLogic operandPUSHBTN 1 LED CTLANDSETTINGFLASH MESSAGETIMETRST0PUSHBUTTON ONLATCHEDLATCHED/SELF-RESETANDFrom user-programmablepushbuttons logicsheet 1, 842021A2FLEXLOGIC OPERANDPUSHBUTTON 1 ONFLEXLOGIC OPERANDPUSHBUTTON 1 OFFSETTINGFLASH MESSAGETIMETRST0Instantaneousreset *LCD MESSAGEENGAGE MESSAGESETTINGS= XXXXXXXXXXPUSHBTN 1 ID TEXT= XXXXXXXXXXPUSHBTN 1 ON TEXTThe message is temporarily removed ifany keypad button is pressed. Ten (10)seconds of keypad inactivity restoresthe message.LCD MESSAGEENGAGE MESSAGESETTINGS= XXXXXXXXXXPUSHBTN 1 ID TEXT= XXXXXXXXXXPUSHBTN 1 ON TEXTInstantaneous reset will be executed if anyfront panel button is pressed or any newtarget or message becomes active.842024A1.CDRORFLEXLOGIC OPERANDPUSHBUTTON 1 ONPUSHBUTTON 2 ONPUSHBUTTON 3 ONPUSHBUTTON 16 ONFLEXLOGIC OPERANDANY PB ONThe enhanced front panel has 16 operands;the standard front panel has 12NOTE