GE JGB908 Owner's Manual & Installation Instructions

Also see for Profile JGB918SELSS: Dimensions and installation information

GE JGB908 Owner's Manual & Installation Instructions Manual pdf 42 page image

BEFORE YOU BEGINRead these instructions completely and carefully.Installation of this range must conform with localcodes, or in the absence of local codes, with theNational Fuel Gas Code, ANSI Z223.1/NFPA.54,latest edition. In Canada, installation must conformwith the current Natural Gas Installation Code,CAN/CGA-B149.1 or the current Propane InstallationCode, CAN/CGA-B149.2, and with local codes whereapplicable. This range has been design-certified byCSA International according to ANSI Z21.1, latestedition and Canadian Gas Association accordingto CAN/CGA-1.1 latest edition.As with any appliance using gas and generating heat,there are certain safety precautions you should follow.You will find these precautions in the Important SafetyInformation section in the front of this manual. Readthem carefully.• IMPORTANT – Save theseinstructions for local electrical inspector’s use.• IMPORTANT – Observe allgoverning codes and ordinances.• Note to Installer – Leave these instructionswith the appliance after installation is completed.• Note to Consumer – Keep this Owner’sManual and Installation Instructions for futurereference.• Note – This appliance must be properly grounded.• Servicer – The electrical diagram is in an envelopeattached to the back of the range.• Skill level – Installation of this appliance requiresbasic mechanical skills.• Proper installation is the responsibility of theinstaller.• Product failure due to improper installation is notcovered under the Warranty.Installation RangeInstructionsDo not store or use combustible materials, gasoline orother flammable vapors and liquids in the vicinity ofthis or any other appliance.If you smell gas:Open windows.Don’t touch electrical switches.Extinguish any open flame.Immediately call your gas supplier.FOR YOUR SAFETY42In the Commonwealthof Massachusetts• This product must be installed by a licensedplumber or gas fitter.• When using ball type gas shut-off valves, they shallbe the T-handle type.• A flexible gas connector, when used, must notexceed 3 feet.TOOLS YOU WILL NEEDFlat-blade screwdriverPipe wrenches (2)(one for backup)Phillips screwdriverOpen-end oradjustable wrenchPencil and rulerLevelDrill, awl or nailMATERIALS YOU MAY NEED• Gas line shut-off valve• Pipe joint sealant or UL-approved pipe thread tapewith Teflon* that resists action of natural and LP gases• Flexible metal appliance connector (1/2 ″ I.D.)A 5-foot length is recommended for ease of installationbut other lengths are acceptable. Never use an oldconnector when installing a new range.• Flare union adapter for connection to gas supply line(3/4 ″ or 1/2 ″ NPT x 1/2 ″ I.D.)• Flare union adapter for connection to pressureregulator on range (1/2 ″ NPT x 1/2 ″ I.D.)• Liquid leak detector or soapy water.• Lag bolt or 1/2″ O.D. sleeve anchor (for concretefloors only).*Teflon: Registered trademark of DuPont