4-6 L60 Line Phase Comparison System GE Multilin4.2 EXTENDED ENERVISTA UR SETUP FEATURES 4 HUMAN INTERFACES4The software prompts for a template password. This password must be at least four characters in length.3. Enter and re-enter the new password, then click OK to continue.The settings file template is now secured with password protection.When templates are created for online settings, the password is added during the initial template creation step. Itdoes not need to be added after the template is created.d) VIEWING THE SETTINGS TEMPLATEOnce all necessary settings are specified for viewing, users are able to view the settings template on the online device orsettings file. There are two ways to specify the settings view with the settings template feature:• Display only those settings available for editing• Display all settings, with settings not available for editing greyed-outUse the following procedure to only display settings available for editing:1. Select an installed device or a settings file from the tree menu on the left of the EnerVista UR Setup main screen.2. Apply the template by selecting the Template Mode > View In Template Mode option.3. Enter the template password then click OK to apply the template.Once the template has been applied, users are limited to view and edit the settings specified by the template. The effect ofapplying the template to the phase time overcurrent settings is shown below.Figure 4–4: APPLYING TEMPLATES VIA THE VIEW IN TEMPLATE MODE COMMANDNOTEPhase time overcurrent settings window without template applied.Phase time overcurrent window with template applied viathe command.The template specifies that only the andsettings be available.Template Mode > View In Template ModePickup Curve842858A1.CDR
