GalileoSky GLONASS/GPS v5.1 (223) User’s ManualGalileoSky Ltd Page 197.6 Signaling functionSignaling function allows assigning the response to:1. analog input state change;2. strikes and inclines (accelerometer data);3. location change;4. speeding;5. iButton or RFID card connection.The Terminal can react by inverting outputs state, sending an output pulse, sending SMS, making a presetnumber(s) telephone call, taking a picture or recording the point.The settings that users can change are as follows (section Signaling setting):1. the time when input signals are not processed (“green wave”), with signaling enabled;2. the maximum time of alert mode after which the Terminal will automatically change into an alarmsystem mode;3. the time between activation and change to the alert mode individual for each input;4. an SMS text message when changing to the alert mode individual for each input;5. the time between enabling the alert mode and state change individual for each input.Alarm mode states change diagramAlarm system activation and deactivation can be made by input, SMS or server message, using the iButtonkey previously programmed in the Terminal (the iButtons command, section Digital inputs setting).Commands prevail over inputs states. Input activation depends on the settings given by the InCfg command(section Analog-discrete inputs setting), the level, outputs are inverted with respect to, is set by the Outcommand (section Transistor outputs setting).Alarm mode«Green wave»Signaling is off Signaling mode Timeout beforealarm modeSMS, GPRS,calls, picturesOutputsactivationAlarm system input is deactivated, iButton is on ora command is sent from signalingAlarm input isactivated,iButton is onor commandis sentTimeout isexpiredTimeout isexpiredTimeout isexpiredSensor oraccelerometerinput is activated“Alarm button” input is activatedAlarm mode time is expired