GalileoSky GLONASS User Manual
                                                                                             | |
Contents
| 
GalileoSky GLONASS/GPS v5.1 (223) User’s ManualGalileoSky Ltd Page 237.14 Power savingTo reduce power consumption of the Terminal in the operating mode, perform the following steps:1. For RS232 port, execute RS2320 0 or or specify "nothing" as the peripheral type in the Configurator.2. Turn off the integrated CAN-controller if the Terminal is not connected to a CAN-bus. This can beperformed by using CANREGIME command with the first parameter set to 0, or by specifying "CANdisabled" as the filter type in the Configurator.3. Turn off the Autoinformer when it is not in use. This can be done by sending AUTOINFORMERcommand with the first parameter set to 0, or by unticking the Autoinformer section of theConfigurator.4. Reduce the degree of track details. The lower this degree, the less the power consumption.To reduce power consumption of the Terminal at a stop, perform the following steps:1. Set up the shutdown of the GPS/GLONASS unit at a stop, this can be performed by using SLEEPMODEcommand (section Service commands) or on the Power saving tab in the Configurator.2. Enable the deep sleep mode at a stop. The deep sleep mode is turned on at the end of a pre-specifiedtime period at a stop. In this mode the Terminal disables the specified modules (GPRS, CAN, RS232,RS485, microSD), reduces the ADC sampling rate, does not sample 1Wire sensors and does not chargethe battery. The behaviour in the deep sleep mode can be configured by using SLEEPMODE command(section Service commands) or on the Power saving tab of the Configurator. It is possible to setup aperiod of connection to a server in the deep sleep mode.7.15 Remote configurationRemote configuration can be performed through several data transfer channels:1. SMS. The Terminal has a list of 4 authorized phone numbers, the messages from which are treatedas configuration commands. The available commands are described in the section Settings for SMScontrol. A phone number can be added to the list of authorized numbers either through theConfigurator, or by sending a message with AddPhone command.2. GPRS. Commands can be sent from the monitoring data processing server. The format of thecommands is described in the section Server exchange protocol.3. GPRS. Commands can be sent via the Configurator and the remote configuration server of GalileoSkyLtd. In this case, the Terminal supports two parallel connections: the first – with the monitoring dataprocessing server, and the second – with the remote configuration server. Remote configuration canbe enabled using RemoteConfig 1 command (section Service commands). It is possible to sendcommands to the Terminal, to receive current information from the sensors connected and toreceive diagnostic messages, when working with the remote configuration server. Using theConfigurator it is possible to create a command pack to configure the Terminal and to save it on theserver. These commands will be sent to the Terminal when it establishes the connection to theserver. |
manualsdatabase
Your AI-powered manual search engine