GalileoSky GLONASS/GPS v5.1 (223) User’s ManualGalileoSky Ltd Page 459.4 Command mode tabThis tab is intended to message a single command or a set of commands to the Terminal.The command mode has the following buttons:1) Run commands;2) Run single command;3) Open from file;4) Save to file.The commands will be identified whether you use capital or lower-case letters or both in turn.Attention!There are no spaces in command name!Spaces between parameters are not allowed!Commands and parameters are separated by space.Commands are separated by Enter.Single command exampleAn example of a command with a parameter:Enter APN internet.beeline.ru,beeline,beeline as shown in the figure above and press Run single commandbutton. The command and a response will be displayed in the Responses window.Command: APN internet.beeline.ru,beeline,beelineResponse: GPRS: APN=INTERNET.BEELINE.RU, user=BEELINE, pass=BEELINETo access the parameters in the Terminal memory you should use a command without parameters!An example of a command without a parameter:APN command Request: APNResponse: GPRS:APN=INTERNET.BEELINE.RU,user=BEELINE,pass=BEELINE
