GalileoSky GLONASS User Manual
                                                                                             | |
Contents
| 
GalileoSky GLONASS/GPS v5.1 (223) User’s ManualGalileoSky Ltd Page 381. Connect the RS485A, RS485B, GND contacts of the Terminal and the RS485A (contact 1), RS485B(contacts 2), GND (contact 6) of the dosimeter correspondingly. Dosimeter has separate powersupply.2. Configure the RS485 port in the Terminal to operate with fuel sensors, photo cameras anddosimeter. It can be done by the RS485FN 2 command or in the Configurator on Settings\Digitalinputs tab.3. Specify dosimeter data in the transmission protocol to the server. If dosimeter data sending is off,the Terminal will not sample ДБГ-С11Д.4. Turn on the Terminal`s archive dynamic structure. Dosimeter data are not stored in the archive byusing the static structure.5. Reset the Terminal.8.18 Connecting PressurePro tires pressure monitoring systemPressurePro tires pressure monitoring system enables to carry out continuous control of pressure in tiresand tire temperature and warns about critical situations. The system consists of wireless pressure sensors,installed on tires, and monitor,receiving data from sensors. The Terminal connects to PressurePro monitorvia RS232 interface and receives data about sensors state and measured parameters.Connecting PressurePro:1. Connect RXD, TXD, GND contacts of the Terminal and TXD (white), RXD (green), GND (black)contacts of monitor correspondingly. Monitor has separate power supply.2. Configure the RS232 port in the Terminal to operate with PressurePro. It can be performed bythe RS2320 13 command or in the Configurator on Settings\Digital inputs tab.3. Specify PressurePro data in the transmission protocol to the server.4. Turn on the dynamic structure of the Terminal`s archive. PressurePro data are not stored in thearchive by using the static structure.By default, PressurePro sensors transmit data once in 5 minutes or by emergency arising (tripping sensors,pressure reduction and etc.). The Terminal transmits PressurePro data to the server by analogy: once in 5minutes or by emergency arising, data are not transmitted at passing points to save GPRS-traffic. Operationof up to 34 sensors is supported.8.19 Connecting CarrierDataCOLD500, ThermoKing, Euroscanrefrigeration units temperature recordersTemperature recorders allow transmitting the information about the refrigerator state to the Terminal,which, in its turn, sends to the server the following transformed data:1. Operation mode of refrigeration unit;2. Cargo temperature (for one- and multi temperature units);3. Alarm signals;4. Total time of engine operation.Connecting a temperature recorder:1. Connect RXD, TXD, GND contacts of the Terminal and TXD, RXD, GND contacts of temperaturerecorder correspondingly. Temperature recorder has separate power supply.2. Configure the RS232 port in the Terminal to operate with one of temperature recorder types. Itcan be performed by the RS2320 command (DATACOLD500: RS2320 11, ThermoKing: RS2320 14,EuroScan: RS2320 15) or in the Configurator on Settings\Digital inputs tab.3. Specify temperature recorder data in the transmission protocol to the server.4. Turn on the dynamic structure of the Terminal`s archive. Temperature recorder data are notstored in the archive by using the static structure. |
manualsdatabase
Your AI-powered manual search engine