Garmin GPS III Owner's Manual

Also see for GPS III: Declaration of conformity Quick guide Owner's manual Owner's manual

You can use the sky view to help determine if any satellites are being blocked,and whether you have a current position fix (indicated by ‘2D Navigation’ or ‘3DNavigation’ in the status field). You can also set the sky view to a ‘Track Up’ config-uration, causing the top of the sky view to align along your current track heading.When the receiver is looking for a particular satellite, the corresponding signalstrength bar will be blank and the sky view indicator will not be highlighted. Oncethe receiver has found the satellite, a hollow signal strength bar will appear, indicat-ing that the satellite has been found and the receiver is collecting data from it. Thesatellite number on the sky view will appear highlighted. As soon as the GPS III Pilothas collected the necessary data to calculate a fix, the status field will indicate a 2Dor 3D status. (For ‘2D’, you may need to enter your altitude. See page 32.)Receiver StatusReceiver status is indicated at the top left of the page. The status will be shownas one of the following conditions:Searching— the GPS III Pilot is looking for any available satellites in view.AutoLocate— the GPS III Pilot is initializing and collecting new almanac data. Thisprocess can take up to 5 minutes, depending on the satellites currently in view.Acquiring— the receiver is collecting data from available satellites, but has notcollected enough data to calculate a position fix.2D Navigation— at least three satellites with good geometry have been lockedonto and a 2-dimensional position fix (latitude and longitude) is being calculat-ed. ‘2D Diff’ will appear when you are receiving DGPS corrections in 2D mode.3D Navigation— at least four satellites with good geometry have been lockedonto, and your position is now being calculated in latitude, longitude and alti-tude. ‘3D Diff’ will appear when you are receiving DGPS corrections in 3D mode.‘2D Navigation’ means theGPS III Pilot has determined ahorizontal position (latitude/longitude), but is unable todetermine altitude. Additionalsatellites may be needed.‘3D Navigation’ means theGPS III Pilot has determineda horizontal and vertical posi-tion (latitude, longitude andaltitude). The receiver isready for navigation.28REFERENCESatellite Status Page