To designate a GOTO waypoint from a list of waypoints:1. Highlight the desired waypoint on the list and press GOTO/NRST. A confirmation pageshows the selected destination waypoint.2. Press ENTER to confirm the selected waypoint and begin navigating.To GOTO an existing waypoint on the map display:1. Use the rocker keypad to place the crosshair on the desired target waypoint.2. Press GOTO/NRST, followed by ENTER, to begin navigating.To GOTO any position on the map display:1. Use the rocker keypad to place the crosshair on any position you wish to navigate to.2. Press GOTO/NRST to create a waypoint, called ‘MAP’, at the crosshair position. Eachtime you perform this step, it will overwrite any previously created ‘MAP’ waypoint.3. Press ENTER to being navigating.To select a GOTO waypoint by facility name or city (applicable to airports,VORs and NDBs only):1. Press GOTO/NRST and select the ‘Spell n Find’ tab, as described on the previous page.2. Highlight the facility name or city name field, as desired, and press ENTER.3. Use the rocker keypad to enter the facility name/city. As you enter the first few char-acters, the GPS III Pilot’s Spell n Find feature will scroll through the database, display-ing any waypoints which match the letters you have entered. When searching by cityname, there may be mulitiple waypoints for the same city. Continue scrolling with theUP/DOWN portion of the rocker keypad to scroll through these entries.4. When the desired waypoint appears, press ENTER.By highlighting a waypointidentifier on a list and press-ing GOTO/NRST, you won’thave to manually enter theidentifier for the waypoint.A GOTO can also be initiatedfrom the map display by plac-ing the panning pointer on thedesired target waypoint.62REFERENCEGOTO