Garmin GPS III Owner's Manual

Also see for GPS III: Declaration of conformity Quick guide Owner's manual Owner's manual

4. Place the adhesive side of the smooth piece of Velcro on the bottom of the bracket(inside the large rectangular recessed area), and press into place.5. Mount the bracket in place by placing one piece of Velcro on top of theother.To insert the GPS III Pilot into the bracket:1. Remove the upper half of the mounting bracket by unscrewing the pivot knob(shown at bottom right) and sliding the upper bracket off the pivot pins of thelower bracket.2. Mate the two clips (opposite the thumb tab) on the upper bracket with thenotches on the bottom of the GPS III Pilot.3. Rotate the GPS III Pilot into place in the upper bracket and snap the thumbtab clips into the notches on the top of the GPS III Pilot.4. For additional security, place the 3mm locking knob into the hole at the rearof the upper bracket and GPS III Pilot. (Use only the knobs supplied. Usingincorrect hardware may damage the mount and/or GPS III Pilot.)To reassemble the bracket and adjust viewing angle:1. Match the pin holes on the upper bracket with the pins on the lower bracketand slide together.2. Place the pivot knob through the side of the lower bracket and the screwinto the upper bracket, but do not tighten.3. Rotate the upper bracket to the desired viewing angle and tighten the pivotknob.89APPENDIX AMounting InstructionsThumb TabUpper BracketPivot KnobLower Bracket