Gemini GEM-P801 Installation Instructions Manual

Also see for GEM-P801: Datasheet

Gemini GEM-P801 Installation Instructions Manual Manual pdf 16 page image

16WI1089 GEM-P801 Installation InstructionsReceiver Formats: Ademco Slow, RadionicsFast, Silent Knight Fast and Universal HighSpeed. This is a sophisticated data formatused to enhance the speed and check theaccuracy of the received transmission. Thisformat should be used whenever the centralstation has this capability. Instead of sendinga second round to verify correct data, thepanel sends a Sumcheck digit after sendingthe Subscriber ID and Alarm Code.(3) Single Digit - 3/1 Format. 3-digitSubscriber ID number and a 1-digit AlarmCode will be transmitted.(4) No Handshake - (All receiver formatsexcept Pager Format)If programmed no Handshake/Kissoff isrequired by the panel.[34]Zone Report, Telco 1Select zone(s) required to send an alarmreport to Telephone Number 1.[35]Zone Restore Report, Telco 1Select zone(s) required to send a restorereport to Telephone Number 1. The zoneswill send a restore after Bell time-out, unlessprogrammed as silent zones.[36]System Reporting, Telco 1(1) Keypad Fire - Program to activate aKeypad Fire report (7G).(2) AUX/AMBUSH - Program to activate anAUX or AMBUSH report (8G).(3) Panic - Program to activate a Panicreport (9G).(4) Test Timer - Program to activate a TestTimer report.[37]System Reporting, Telco 1(1) AC Fail Report - Program to activate anAC Fail report (15 minute fixed reportdelay).(2) Low Battery Report - Program toactivate a Low Battery report.(3) *Trouble Report - Program to activate aTrouble report.(4) Fire Report - Program to activate a Firereport.*Includes Bell Cut, Fire Trouble, ReceiverFail-to-Respond, Receiver Tamper,Receiver JAM, Wireless Smoke LowBattery, Wireless Smoke Supervisory Fail.Point ID format will report trouble(s) bydevice and ID number.[38]System Restore Report, Telco 1(1) AC Restore - Program to activate an ACRestore report.(2) Battery Restore - Program to activate aBattery Restore report.(3) Trouble Restore - Program to activatea Trouble Restore report.(4) Fire Restore - Program to activate aFire Restore report.[39]Opening/Closing Report, Telco 1Select users required to send opening andclosing reports to Telephone Number 1. Donot program for users that are intended tosend an Opening After Alarm (CancelCode) or Conditional Closing reports.Backup Telephone Programming[40]Subscriber ID Number (Telco 2)For 4/2 format enter a 4 digit number. If 3/1format is required enter a 3 digit number thenpress the F key.[41]Telephone Number 2Program the phone number to be dialed forTelephone Number 2. A fixed dial tonedetection (E) is included prior to the DialingPrefix [44]. Dial tone detection can bedisabled by programming No Dial ToneDetection [46-1]. To program any additionaldelay enter a "D" where required in the phonenumber.[42]Receiver Format (Telco 2)Select the format that will be used to reportfor Telco 2 (Backup reporting). Refer tosection [32].[43]Receiver Options (Telco 2)Refer to section [33] Receiver Options.