Gemini GEM-P801 Installation Instructions Manual

Also see for GEM-P801: Datasheet

Gemini GEM-P801 Installation Instructions Manual Manual pdf 18 page image

18WI1089 GEM-P801 Installation Instructionseach time a report is sent.(2) Reserved(3) Reserved(4) ReservedTelephone 3 Programming[50] - [59]Programming is the same as for Telco 1.Program to split/double report to Telco 3.Refer to sections [30] through [39].Report Codes[60]Zone Report CodesReport Code for Zones 1 through 8.4/2 format - The Zone Report Code is the 1stdigit of the report code sent, the second digitis the zone number of the reporting zone.For example, if zone 2 has a report code of 3,the report code would be 32.3/1 format - Sends only the report Code anddoes not append it with the zone number.[61]Point ID Report CodesPoint ID Report Codes are defaulted toBurglary for zones 1 through 8. Optionally,Point ID codes for zones 1 through 8 can beprogrammed as follows:[1] Fire [7] Gas Alarm[2] Panic [8] Heat Alarm[3] Burglary [9] Reserved[4] Holdup [A] Auxiliary[5] General Alarm [B] 24 Hour[6] Reserved[62]Zone Codes[62-1] Restore code - Zones 1 through 8.The second digit of the restore code is thezone number of the restored zone. Forexample, if the Zone Restore Code [62] isprogrammed to E, the restore code for thatzone would be E4 (4/2 format).[62-2] Trouble Code - Conditional ClosingReports. Zones that are bypassed at thetime of arming send this code along with thezone number of the bypassed zone(s). Forexample a conditional closing by User 2,with zones 2 and 3 bypassed would be asfollows: 1234 C2F2F3[63]System Report CodesProgram a 2-digit report code for KeypadFire, Keypad AUX, Keypad Panic, TestTimer, AC Fail, Low Battery, Trouble andFire.[64]System Restore CodeThe code sent when a system conditionrestores. The second digit of the 2-digitrestore code is the second digit of theSystem Report Code [63]. For example, if aLow Battery System Report Code is F8 theBattery Restore would be E8 (4/2 format).[65]Opening and Closing CodesProgram Opening and Closing Codes forUsers 1 through 8. The second digit of thereport code is the number of the user thatarmed or disarmed the system. For example,if the Closing Code [65] is programmedwith a C, the closing code for User 2 wouldbe C2 (4/2 format).[66]Ambush Report CodeProgram a 2-digit report code for Ambush.To send an ambush report, program a UserCode for User 8, Program report User 8 asAmbush [20-4] and Select reporting for Telco1 [36-2] and/or Telco 3 [56-2].Enhanced CommunicatorFeatures[67]Telephone Number 1(1) Opening After Alarm (Cancel Code) -When enabled, all users that are not selectedto report on Opening/Closing [39] will reportan Opening only when opening after analarm has occurred.(2) Conditional Closing Telephone 1 -When enabled, all users that are not selectedto report an Opening/Closing ([39], [59]) willreport a Closing only when zones have beenbypassed. The Zone Trouble Code [62-2] isused to report zones that have beenbypassed at the time of the closing report.