Gemini GEM-P801 Installation Instructions Manual

Also see for GEM-P801: Datasheet

Gemini GEM-P801 Installation Instructions Manual Manual pdf 17 page image

17[44]Dialing PrefixDialing prefix for Telco 1, Telco 2, and Telco3. Program if using an Outside accessnumber.[45]Communicator Features 1(1) Communicator Enabled - Program toenable the communicator.(2) DTMF with Rotary Backup - The firstattempt to communicate is dialed using theTouchTone method of dialing, subsequentattempts are dialed using the pulse methodof dialing. Disable this feature to dial usingonly rotary dialing.(3) DTMF only - All attempts to communicatedial using the TouchTone method of dialing.(4) Backup Reporting to Telco 2 - After 2attempts are made to communicate to Telco1 the backup phone number is dialed (Telco2).[46]Communicator Features 2(1) No Dial Tone Detection - Program todisable dial tone detection for Telco 1, Telco2 and Telco 3.(2) 2:1 Rotary Dialing - Changes the makebreak ratio when rotary dialing from 1.5:1 to2:1.(3) Backup if < 4 attempts - If BackupReporting [45-4] has been enabled, thecommunicator will use Telephone Number 2[41] for the remaining retries when there areless than 4 retries remaining.(4) Don't Clear Fail to CommunicateProgram to prevent a good line cut test fromclearing a Failure to Communicate systemtrouble. If programmed, only a successfulcommunication to Central Station will cleara Failure to Communicate system trouble.Pager ProgrammingIf Pager Format ([32]and/or[42]and/or[52] =7) is selected, pager data will be displayedas shown in Figure 8. If Pager Format isselected 4/2 format must be programmedand Sumcheck is not permitted. If a PINnumber is required refer to Leading Digits[47].Pager Alarm data is the same as 4/2 formatwith the exception that the 2 digit ReportCode is transmitted before the 4 digitSubscriber ID.[47]Leading DigitsPager PIN Number - If a PIN number isrequired by the paging system, program thePIN number in the Leading Digits location.See sample program below.If a 7-digit PIN number is required, programthe panel as follows:[31]/[41]/[51] - Pager Telephone number[32]/[42]/[52] - Select Pager Format[47] - X X X X X X X CLeading and Trailing digits can be letters B, Cor D. B = the * button on a telephone, C =the # button on a telephone, D = 2 seconddelay.[48]Trailing DigitsTransmitted after alarm data. Refer tosection [47] for programming information.[49]Pager Options(1) Skip Alarm Data - Once pager format isselected, program this option to skip alarmdata. If this option is selected, all theprogrammed Leading and Trailing digits aresent, but the event code and subscriber IDare not transmitted. With this optionselected, a telephone number programmedin Leading Digits or Trailing Digits wouldsend the telephone number to the pagerDigits in Report Codes and subscriber IDs that areprogrammed with "B" through "F" will be converted to "0"s.NOTE:000 033-1234Leading DigitsReport CodeSubscriber ID NumberFIGURE 8 DEFAULT P AGER DISPLAY7-digit PIN Number Terminating Digit (#)