Gemini GEM-P801 Installation Instructions Manual

Also see for GEM-P801: Datasheet

Gemini GEM-P801 Installation Instructions Manual Manual pdf 9 page image

9keypad will beep 6 times, indicating the panel hasbeen disarmed. The red Armed LED will go out.If an incorrect Arm/Disarm Code is entered, thekeypad will sound a 1-second tone, indicatingincorrect entry. Press the C key and re-enterthe code.Disarming after an Alarm (Alarm Memory)The armed LED and the zone(s) that caused thealarm will be be flashing. Disarm the panel. Thesystem is currently not detecting zone faults ordisplaying system trouble. The zone(s) thatcaused the alarm will continue to flash. TheSTATUS and HSYSTEM TRBL LEDs are outindicating:The system is displaying Alarm Memory.Press the C key to clear Alarm Memory.BypassingAutomatic BypassingNote: Automatic Bypassing has not beenevaluated by ULHome/Away with Delay ZonesThis zone type has the following operationdepending on whether an Exit/Entry Zone hasbeen violated during the Exit Delay time.HomeExit/Entry Zone is not violatedZones selected as Home/Away with DelayZones will be bypassed automatically.Away with DelayExit/Entry Zone is violatedZones selected as Home/Away with DelayZones will have a fixed 20-second entrydelay when violated before an Exit/EntryZone.Full Setting the System with AutomaticBypassing - Home/Away with DelayZonesFrom the KeypadPress BC to return protection toHome/Away with Delay Zones that havebeen automatically bypassed. Threeminutes are allowed to walk through Exit/Entry and Exit/Entry Follower Zones.Using A Keyfob (GEM-KF)All zones in the system can be armedregardless of the state of the Exit/EntryZone when arming with a Keyfob and usingan AUX key programmed as Full Set.Press [ON] and press and hold the [A1] or[A2] keys for 1.5s when leaving thepremises. All zones, including Home/AwayZones are armed.Bypassing a zonePress the B key, then the zone number tobe bypassed. While the panel is DISARMED,the bypassed zone LED will flash slowly;indicating the zone has been bypassed. Whilethe panel is ARMED, the bypassed zones willonly be displayed if the Display Bypassed [21-3]option has been selected.Unbypassing a zone (Disarmed only)Press the B key then the number of thezone to be unbypassed.Group BypassPress the E key to Bypass all Exit/EntryFollower Zones [02] or Home/Away Zones[01] (only if the system is programmedexclusively for Home/Away with Delayzones).Using A Keyfob (GEM-KF)Hold the [A1] or [A2] key on the Keyfob toBypass all Exit/Entry Follower Zones [02] orHome/Away Zones [01] (only if the system isprogrammed exclusively for Home/Away withDelay zones).User Program ModeTo prevent the loss of the User 1 Code, the paneldefault program includes User 1 Code Lockout[96-2].To change the User 1 Code from its default valueof 1234, program the 4-digit User 1 Code throughDealer Programming [95]. User 1 Arm/Disarmcode is also used to program User Codes 2 - 8.By default, the User 1 code cannot be re-programmed by the user.If it is necessary to change the User 1 code, itcan be changed through downloading or Dealerkeypad programming. From Dealer ProgramMode, change the User 1 Code Lockout ([96-2]LED=OFF) to disabled.Entering User Program Mode